Mazda Protege 03 crank sensor test

The sensor was good, oscilloscope was not set properly but tgat was the preset on the verus for that test on that car, engine skipped 5 teeth on the timing belt cause the harmonic balancer was slipping on the rubber part causing extreme heat causing the timing cover to melt, some of that plastic was found inside the belt are, timing belt job done car ran perfectly

[@fifove]

Did you have p0340 cod?

[@pmscompany]

Bueno y que era al final?

[@pinpointautodiagnosticsene9655]

Fuera de tiempo, brincó la correa

[@raycenser]

Tengo un Mazda protege del 2000 lo prendí y cuando lo puse en retroceso apago y hace el mismo problema pero la correa de tiempo es nueva se la cambie va 1 año