Mazdaspeed Datalogging Instructions (How to Datalog your Mazdaspeed 3/6 Using a V3 Cobb AccessPort)

A video I created for my Mazdaspeed remote tune customers demonstrating how to perform the various types of datalogs required for Remote Tuning (E-Tuning) a Mazdaspeed 3 or 6. Keep in mind that these are the generic datalogging guidelines for these cars. Your vehicle and specific setup may require different datalogging methods or parameters however these are the general methods most commonly used and required.
The 3 Basic forms of datalogs demonstrated are:
1) Idle Datalog - This allows me to analyze how the engine is running at idle especially in relation to RPM, AFR, and Fuel Pressure
2) Mass Air Flow Calibration (MAF Calibration) Datalog - This allows me to calibrate for the appropriate fuel delivery by analyzing fuel trim data in relation to the Mass Airflow Sensor's Voltage output. This must be done on every vehicle and is different for every brand & size of intake.
3) 4th Gear WOT Datalog - This allows me to optimize the engine for maximum power potential by dialing in boost, fuel, and ignition timing and analyzing how the engine sweeps through 4th gear at Wide Open Throttle (WOT). 4th Gear will provide the best load & boosting characteristics which is why this datalog must be done in 4th. Doing this log in other gears for tuning purposes will result in potential engine failure as the tune will not have been properly calibrated for the best loading characteristics that the engine sees.
For Remote Tuning options, visit www.tunedbynish...
Recommended Logging Parameters:
Accel. Pedal Pos.
Actual AFR
Boost
Boost Air Temp.
Calculated Load
Coolant Temperature
HPFP Act. Press.
Inj. Duty Cycle
Inj. Pulse Width
Intake Temp.
Intake Valve Advance
Knock Retard
Long Term Fuel Trim (LTFT)
MAF Voltage
Mass Airflow
RPM
Short Term Fuel Trim (STFT)
Spark Advance.
Throttle Position
Vehicle Speed
Wastegate Duty
www.tunedbynis...
/ tunedbynishan
/ tunedbynishan