Mcculloch 10 series piston change

[@j.c.lawntreesnow6272]

Hi hopper i tore one of my 610s down the other day and notice it dint have clips holding the rist pin in .nice to see this vid .the exhaust port had two obstructions on each side of the port there gone now lol.

[@G_Carter]

Very interesting. Thanks, Bell hopper! Stay well.

[@mikefriesdrums]

I just put a piston in a 10-10 and was worried it had to go a certain way, sounds like I got lucky. Thanks for the video hopper!

[@dyer2cycle]

...man, that little press looks mighty handy...much better than a notched block of wood and a brass hammer...

[@davefournier7135]

Good intel right there hoss. Thank you

[@justincastillo3185]

Excellent video jereme. Clear information on a somewhat difficult process. 👍👍👍👍

[@tazman-kennyfuller]

Thanks for the great info Hopper.🌲❤🌲✊

[@hotboxpizzatruck]

Like a glove!

[@leonardvirtue5753]

Mr bell.👍 bloody good mate Cheers.👍

[@jeremywever6947]

👍🔥 love them Macs

[@simpleman4224]

Learned something new! Thanks buddy!👍👍👍👍🇺🇸🇺🇸🇺🇸🇺🇸🙏🙏🙏🙏

[@joecochran9976]

Thanks for sharing your knowledge and experience. Take care and be safe.

[@TeDoFwAr]

You Sir, are outstanding! Thanks, great content keep up the good work!

[@G-PA-2795]

Nice! Slick deal.

[@PowerBeeEngine]

Dang. Thanks! I'm trying to figure out how to swap the piston's on a MC49 (kart racing engine). This video helps.

[@SOHN32]

And somewhere in Bellhooper work shop there is a puddle now or a tootie roll. Lol Nice phone work with camera. You try settings see on turning off fouces.

[@ghettotech9617]

Cool always wonder how to change apiston

[@leighanneedney7548]

Would you consider making the attachment to press these out and sell them

[@lukepritchard9686]

Hey man, now I don’t know too much about chainsaws/smallengine, but I have a Husqvarna 141 that when you pull to start it, it like jerks around and slows it down so I can’t pull it fast to start, I’m thinking it has something to do with the fly wheel but when I tried to take it off I noticed I don’t have the tool or a center punch to knock it loose. Got any advice on what I should do?

[@bellhoppersaws]

I put a scrench behind the flywheel and twist it to put presure on the flywheel then tap the crank with a brass hammer to pop it loose but you got to be gentle so not to mar the crank

[@lukepritchard9686]

Bell hopper mcculloch chainsaws, so it is a fly wheel problem, would I have to get a new one or I had a buddy say something about realignment

[@Thetreefella]

👍👍👍

[@mistakeone9370]

Anyone know were a guys can find piston rings for a homelite 300 classic?

[@jayjay-xz9sc]

What if it a aftermarket piston and has no markens or a arrow for a super pro 70 which way should the piston go in?

[@justinweaver8787]

Thank you very much I'd took a big freaking hammer to it lol