MCX7 Surface Example 1

[@gachalifegirliluvpink6719]

Have to say.from the way place your camera to techniques and the way showing viewers all are perfect 100% you're smartest instructors on KZbin (because I always learn mastercam on KZbin only)thank you

[@zanesworldofcnc]

I really appreciate it! When I have time I will be making more videos, thanks for watching!

[@jayhernandez9503]

Really appriciate your video Zane just what i needed to feel comfreable into jumping into 3D programming i am already good with standard 2D but this was great.

[@bryantorres8786]

Great Video!

[@gachalifegirliluvpink6719]

Again,hope you post more about toolpath 3D.....thanks

[@donmumma5582]

really helpful thank you how would you put a 10 degree taper on the floor

[@zanesworldofcnc]

DON MUMMA Depending on what direction you want the taper (into the floor or out of the floor) You could use a lofted surface at +/-80deg or You could translate the half sphere in the middle up or down along just the Z axis and then create a surface from inner edge to outer edge. (needing a bit a trig to calculate the Z distance for 10deg) Hope that helps!

[@donmumma5582]

thanx Zane I will try it

[@leandromunizgoncalves2228]

Thanks man !

[@subakarthik6626]

Great thanks

[@emmanuellasat9502]

Dat is vele beter dat computers van robotcat op machine om beter stukken make, beetje beter in beste makkelijk CIC machine, of haas machine