How to set up your MS2/Extra air temp, coolant temp, manifold pressure, and o2 sensor calibrations.
Пікірлер: 14
@SGIABC10 жыл бұрын
It says in the description that you would demonstrate o2 sensor calibration, but you missed it in the video. Just thought you should know! :)
@hemilove11 жыл бұрын
thank you so much i am so happy to see that there is someone out there that is willing to help great video BTW. thanks
@dangerousfandango59435 жыл бұрын
My innovate scg1 came with a mac daddy 4 bar, I can input that in, and itll override the 2 bar in the ecu?
@Drifttheorygarage6 жыл бұрын
My o2 isn’t communicating with my ECU. What could be some things to check
@oggramm3 жыл бұрын
How do you change output voltage to crank cam sensor
@earlyhemibill11 жыл бұрын
What will I have to download to my computer? I have the 3v system I believe.
@GrantGrabert9 жыл бұрын
My MS1 does not have the option to calibrate coolant temp sensor and my fan runs from 175 deg on up via TunerStudio. Fan even stays on until battery is dead with engine off and key in run position.
@TEAMCREAM_968 жыл бұрын
its time for an upgrade
@maynorlopez89046 жыл бұрын
Why does ms tps read 10-20% at physical zero of tps.. If even without sensor it reads 7-10%. When trying to calibrate it does not zero out.. ??
@RuweSaare6 жыл бұрын
Did you get a solution for it? I have the same issue.
@Nasonix26 жыл бұрын
I'm having the same problem except my 0% is closed throttle and my WOT only brings the percentage bar up to about 60%. I have been having this problem for a while. Any solutions?
@maynorlopez89046 жыл бұрын
Ruwe Saare no solution. As a matter of fact, it was working perfectly until the week I was getting closer to finishing build. I re wired all my harness just to make sure and it aggravating
@nytovaok5166 жыл бұрын
same. mine isn't even being picked up by the ms at this point. closed throttle and wot both read "2" and there's no change with the little blue bar when i press the accelerator