Mellow VZBot 330 Build Series - Part 3 Power Supply, Super 8 Pro, & 5160 Stepper Wiring

[@Sixpack0000473]

I'm a little bit confused on one part - you said you were not going to wire 48v to the Super 8 but the video footage shows the "HIGH" side with wires connected. Did you change your mind?

[@GregsMakerCorner]

I did connect the high side wiring, but to 24v (not 48v). The 48v is only connected to the 5160 drivers. I can see how it’s a little confusing in the video because the wire colors are the same for both. I cover a bit of the plan at the 26:00 mark.

[@Sixpack0000473]

@@GregsMakerCorner ah okay thanks for clarifying!

[@loloenfrance6405]

Hi Great video. What's the model of rasperry PI DIN mount you used? There is a heatsink?

[@tillburn]

Hi Greg! Nice job. If I could offer one piece of advice. I would use the PA-09's to shape the tabs on those pins. There is a flat spot on the tip of the PA-09 jaws that you can use to straighten up the tabs on those pins. I typically trim the tabs because I buy the cheapest I can get and the tabs are always way too long, after trimming the tabs I straighten them up. I find it's easiest to, trim, straighten, then crimp. I really do appreciate how you talk the audience through your thought process while you are doing it, amazing work.

[@thegps7197]

Great video, perfectly detailed and well explained. Certainly shows how simple the wiring is once you know how

[@patrickbrown6398]

Great content! Thanks

[@Dead_Aim556]

Great video! One recommendation tho clean the lenses. Some shots are fuzzy

[@GregsMakerCorner]

Thanks! I think it was a combination of lighting, bad angles, and movement. This machine was definitely hard to get the right angles with due to the size. I also need to figure out how to get some better camera stands as one of the ones I had broke. :( But definitely agree!

[@michail1963]

I wasnt able to find anywhere which motors are X/X1/Y/Y1...Any advice how do I determine that? Thanks

[@GregsMakerCorner]

I used the documentation on the Vzbot site to work it out. I ended up changing it after the fact also. It wasn’t super clear but I eventually figured it out by looking at that site- hopefully you get it sorted.

[@dvd42_]

i can not for the life of me find the stl for the DIN mount that holds 3 wagos, can only find ones that hold 2, mind sharing it or at least mentioning what website its from?

[@GregsMakerCorner]

I will see if I can dig it up!

[@michail1963]

I see you have 4 pin on/off switch...I got 3 pin in my kit. Not a big deal but 4 pin is more convenient.