Metso ND-9000 Positioner basic settings

[@yourirfankhan1434]

Best define Jabardast Bhai 👌

[@INSTRUMENT_GYAN]

Sir emerson 475 bhi support karega kya

[@instrumentationandsolution5013]

U can use 475..

[@harikrishnan2223]

Can I simulate 0 to 100% traveling by using TREX. Because before I already try. The % value we can send,but valve haven't move. Similar another positioner value we can send by using TREX, or another option in that positioner. So Pls clarify this.

[@instrumentationandsolution5013]

U can do a manual stroke check with the local buttons ... It's very easy... Through hart also u can simulation.. if the positioner has any issue then it will not operate ...

[@INSTRUMENT_GYAN]

Sir positioner power up hart se ho jayega ya miliamps source bhi lagna padega

[@AnilKumar-xo7ot]

mA lagana Hoga .....

[@flossyht6632]

what size resistor you used?

[@instrumentationandsolution5013]

250 ohms

[@NagendraVlogs7485]

Bhai ise stroke chek kaise karenge by trex

[@NagendraVlogs7485]

Hart type

[@instrumentationandsolution5013]

I never did with hart ... If it's communicating then u can start the simulation with changing DIP switch position according to positioner model ...

[@mohsinraza9944]

Useful video

[@shakilakhtar9182]

Hart or mA source ek hi terminal me connect hoga keya?

[@AnilKumar-xo7ot]

Yes u can ....

[@yourirfankhan1434]

Bhai Rotork MOV ke baare me bataiiye

[@instrumentationandsolution5013]

Sorry to say, We are not using ....but I will try

[@yourirfankhan1434]

@@instrumentationandsolution5013 Ok

[@yourirfankhan1434]

@@instrumentationandsolution5013Bhai you make a videos rotex proximity sensor limit switch adjust on off valve

[@Rohit-zc2ew]

Thanks u sir

[@Rohit-zc2ew]

Sir aap density transmitter par video banaye na please

[@bhaveshpanchal6619]

Auto calibration option is not showing after going CAL option what is problem

[@instrumentationandsolution5013]

If there is any error, you need to rectify that 1st ...

[@sanojkumar-ty3rf]

How position feedback doing reverse in programming Like as display 100 we want change 0% when valve do not operate

[@AnilKumar-xo7ot]

Yes you can ..

[@sanojkumar-ty3rf]

@@AnilKumar-xo7ot please help

[@sanojkumar-ty3rf]

When valve physically open but feedback show 0% .I want to change feedback 100% in programming

[@AnilKumar-xo7ot]

@@sanojkumar-ty3rfu can change Rotation or Direction ....parameters in that positioner... Or need to change position of that positioner....

[@washimakram3543]

Bro I need FF type step... If you have any idea then send me.

[@instrumentationandsolution5013]

Sorry ....field bus protocol not available in my present company....