mg3070s how to ciss and right level in ink tank

[@SevenDeMagnus]

Cool thanks. Tip to reduce the occurence of backflow (CISS works using a principle called Mariotte's Bottle/Siphon): measure the heigh of the cartridge's prinhead (where the ink flows in from the ink tanks) with a digital caliper, the holes in the ink tanks (not where the tubes come out but inside the ink tanks where it first exits out) must be the same height as possible with the cartridge. In the Canon MP287, about 56mm (I made a custom tower for the ink tanks for its holes to be at that same height) and seal the silicon rubbers and L plug with silicone grease (makes it easier to plug in the holes too) Try to use silicon grease to seal the top par of the rubber on the cartridge and ends of the tubes. God bless, Rev. 21:4

[@angelicaraon1671]

Hi sir, ano po kaya prob ng printer namin, ganyang model din. Faded po ang print, tapos may excess na black ink sa dulo ng papel everytime magpiprint. Please help 🙏

[@gracebontod7495]

hello po pano po pag nagpapalitan ang ilaw? meron po ba kau video? thanks

[@MyrickCjRamos]

Bakit po kaya sakin d nagfoflow ung ink sa hose

[@masterdjm28]

Paano po mag reset ng ink level bago palang ung printer pero po nag ilaw n agad ung color and black as low ink after ng ilang printing

[@pinaysha7654]

Can we print sticker on this printer??

[@reynaldodelacruz481]

Paano pipapump hindi po makita.

[@markanthonylorgonio75]

Hello po asko ko lang po pano po kaya dpat gawin sa ayaw mag print ng black ink po..pero sa color ok nmn sia

[@bozzberttv7269]

Lodz ganun nangyayari sa printer ko nagpapalit palit ilaw ng power at stop

[@chlienescrochetandsewing7891]

Hello po pwede po ba iconvert ung printer ko canon pixma mg3270 po

[@princesstome4317]

Boss tanong lang po pano wala ung orang light blinking sa Canon mg3070s

[@tatayjay6587]

hm po mag paconvert ng ganyan sir, same model MG3070S po thank you

[@patrishagalang1438]

hello po pwede po ba kayo gumawa pano mag suction ng ganitong model? ty po

[@bozzberttv7269]

Shop location nyo po sir?

[@aldreiadriano769]

Sir bakit sakin sir lagi umaatras ung ink nya pabalik ng tank ano po dahilan non ..

[@maealvievlog3110]

Hi sir may resetter po ba kau nyan?

[@avidplayerexcel9412]

So far there are no available resetters for any MG Series. The only thing they do is replace the logic board of the MG Series. P.S., don't buy MG Series they are worst printer canon has ever created.You should buy the MP Series, G Series and IP2770 only.

[@conniesebastianjaen9683]

Magkano po cost pag ipaconvert sir?

[@digitalbauble]

Kuya Roger, pwede po magpa troubleshoot? I am from Pasig po

[@tazmineh.5644]

sir pwede po ba ito sa canon pixma mg4250?

[@aldreiadriano769]

Paano pag ka install ng hole nya sa loob

[@joenygultiano139]

Sir saan ph location,nyo may epapagawa ako

[@ralphygrijalvo4193]

Sir paano kinabit yung hose?

[@nobreibungubung2585]

Pano po ayusin pag nag papakita error occured pls turn of the printer then on again if there's a problem please go to the echetera.ayaw po magprint eh

[@noobs_hope2125]

Sa akin sir tumatagas ung ink at ayaw dumaliy ung ink

[@dipokarshan_jr_brothers7245]

Sir address bejo na

[@maealvievlog3110]

Ano po mas maganda gawin kapag di na detect yung Cartridge?

[@maealvievlog3110]

May resetter po ba kau?