Depron and Modelling Foam Building Techniques

[@HaraldBendschneider]

6:35 You're the man! This tip saved my day! Thank you!!

[@Eurocub]

I'm about to build my first Depron plane and this gave me some good pointers - thanks

[@savxssfan]

Great Video ! There is another way to transform your Paper Plan to the Depron: Glue it directly on it with a small amount of spray glue or a gluestick. You can easyly peel it off when you are done with cutting. Bending Depron is also possible by using the Edge of a Table: Just pull it gently over the edge - over and over again and put your hands on top of the Depron piece while doing it. it will bend in the directiom of the table edge. I hope you got me, my english language skills are not on point.

[@peterismobiel]

Excelent video. Your parts almost look like laser cut parts.

[@Droneaway-72]

Great tips We’re always told never use a metal rule and a sharp blade because it runs across metal . Always use a wooden one where it digs in.

[@mectorocks564]

1:40 Dont always change the blades like that, the chances of the fresh blade in cutting your finger is high. I had an experience in which I cutted my nerve in the left thumb, so much blood was lost. In my case the blade was not on any table or something, just on my hand, but always be careful. Edit : spelling mistake

[@thercbat]

Nice video. Very helpful 👍👌❤️

[@dracarnoir7606]

Great tips thanks a lot.

[@wizardOfRobots]

my god that marker looks like a mini cannon

[@thetruth8053]

grat video..LIKE.... please,is a 2mm thick depron slightly translucent or not ?

[@MicronWings]

No the 2mm is not translucent at all.

[@lalitg.shelare6134]

Very helpful

[@user-AdiUtomo]

Josss banget

[@rushdanrushil4771]

Is depron the type of foam which is kinda plasticy and sometimes used in packaging?

[@MicronWings]

It is constructed from individual closed cells of polystyrene plastic

[@crashtestrc4446]

Can I use hotglue ?? UHU glue seems to be pricey

[@MicronWings]

Hot glue will glue foam but the problem is that it will also melt the foam. It's not really a solution.

[@crashtestrc4446]

@@MicronWings hey I actually used hot glue and it came wonderfully kzbin.info/www/bejne/apjLfq2DbKimi9E

[@MicronWings]

@@crashtestrc4446 Yes Hot glue will work too. But if it is too hot it will melt the foam when you apply it.

[@crashtestrc4446]

@@MicronWings yes I kept a scrap piece of depron to test out the right heat for the depron

[@Thalarctos.]

💖