Microstrip vs. Coplanar Waveguides

In this video segment, John Coonrod of Rogers Corporation talks about the comparison between Microstrip vs. Coplanar Waveguides. John will further discuss the pros and cons of these two different structures in regards to high frequency performance.
Register to become a member of the Technology Support Hub to access presentations, videos and literature.
landing.rogerscorp.com/6/Tech...

[@Dawntech]

Thanks for the video, very well explained :)

[@user-ew8xi8ku6v]

Good morning. can you help me to understand the calculation of the parameters (g, Wf)of an antenna fed by a coplanar line . thank you.

[@karthika8709]

Hi, In six-layer board, when using Coplanar waveguide trace on the 1st layer. Can I place a +3.3v power trace under antenna trace (5th layer)?In the 2,3,4th layer, I have a ground plane under that trace.

[@hashabdullah6664]

Of course you can, even with just 1 GND layer below, hope this is not late though :-)

[@sukantakumarjena9578]

Hi I would like to know that is there any relation between linewidth and gap width in CPW. the line width should be higher than the gap width always? Or If i design the width of gap and line, is it possible? Is it good or Bad? Could you lease let me know?

[@joelphaneuf-scalise2317]

If your using true CPW the gap widths to ground plane dominate the impedance and usually have to be pretty tight for 50ohms. I would make the center line width 50 ohms microstrip then you can drop the ground planes and transition between CPW and microstrip without any reflections because they're both 50 ohms.

[@ahmetciftci9035]

please add some subtitles.

[@EricsonRG]

It would be better if you use more visual way to explain

[@kusumaoruganti2785]

not audiable :(

[@shravan8848]

robot