MillRight Carve King Day 5

[@lebijohn7631]

i couldnt have assembled the millright carve king without your help thank you very much. could have added one more video of the finishing. Thanks again

[@MyOpion]

the videos have been a great help to me as i put my carve king together. i wish you had the last video posted to finish out the steps. Great guide for a long process.

[@ChrisGagnonDIY]

I am sorry i missed the last section of the video i will look and see if i still have the footage if so i will post it. thanks

[@zdc590]

Jeez man, your videos were awesome when the instructions let me down. Appreciate you going through the trouble.

[@carlgriebno5691]

Hey Chris ... Wondering how the CK runs. Getting ready to bite the bullet on one.

[@ChrisGagnonDIY]

Its been working well. I wish there was an upgraded controller. its a little tricky to get things to scale

[@reycavazos8342]

Do you have a diagram on which is what motor? I'm trying to connect them to the red board and can't figure it out.

[@fugops]

Great videos. Helped me with the assembly of my Carve King. Did you figure out the issue with the gantry being uneven (one side touching the back and the other side not touching the back) when pushed to the back?

[@ChrisGagnonDIY]

I did not but it has not effected my usage. it may have been from the paint moister causing the ends to warp a little. not sure

[@constantmtn]

Is there a final video?

[@ChrisGagnonDIY]

not yet i am working on it though

[@jakemei]

finish yet?

[@wifal6874]

yeah it finished?

[@Olivsam]

What software will you be using with this cnc?

[@ChrisGagnonDIY]

Vcarv and easle

[@timvanmonero2720]

i didnt receive M5x8 machine screws for the aluminium. however the docs say "Run an M5x10 screw through the aluminum angle and into the thread of the T nut". i did M5x10 and now the angle isn'st flush and wobblying around for a fair amount. fail.

[@ChrisGagnonDIY]

I would recommend stopping by lowes or home depot and get a few it will fix the problem i am sure.

[@MyOpion]

the videos have been a great help to me as i put my carve king together. i wish you had the last video posted to finish out the steps. Great guide for a long process.

[@lebijohn7631]

i had to add a thick washer

[@bigeasy_f150]

can you not buy this thing assembled ?

[@ChrisGagnonDIY]

no its a kit