Milwaukee 5616-20 Router Main Bearing Replacement

[@alphaclean3364]

Thank you for this. I had to use an impact gun with a deep ball hex to get that last nut off. Sucker was on TIGHT. Good thing you told me which direction it needed to go before I let er rip

[@Jimmyraver]

Thanks bro. You helped me so much! Hi from Mexico!

[@nathanhenson9060]

Glad I could help!

[@marksleeper9385]

great vid

[@davidbryanwoodworksandmore]

thanks for posting this. my daily 5625 needs new bearing also. not sure if it needs both bearings or just this one. however, ill try just this top bearing. I'm thinking its the same setup. but will check for sure. I do thank you again for posting this. very nice.

[@nathanhenson9060]

My pleasure. I wanted to purchase the top bearing as well, but would have had to source it from another place. Most of the wear & tear on these routers happens at the main bearing near the bit end of the router. Mine has been used for wood as well as for slicing Stainless Steel sheeting. It has held up very well and just needed a little TLC.