Mimaki CGAR Series: How to setup and use ID Cut

[@giftedhandsbyjaviah]

Hi! I just purchased the Mimaki CJV200-160. I’m looking into getting this plotter as well. Who can I contact for more information?

[@pgsignvideo]

I would contact the dealer you purchased the printer from. If you are in North America you could also go to Mimaki USA.com and locate the contact us tab. Mimaki backs up the dealers! CJV200 is amazing!

[@giftedhandsbyjaviah]

@@pgsignvideo Great! Thank you so much! Yes, I’m in North America. Your videos are very helpful :) Do you happen to know if the Mimaki CGAR can cut foam board core or even coroplast?

[@pgsignvideo]

@@giftedhandsbyjaviah TheCGAR will cut vinyl and SBS Paperboard, I think 15mil. To properly cut foamboard a reciprocating knife is best because of foamboard "pilling-up" Do you have room for this: www.mimakiusa.com/cfx-series/

[@giftedhandsbyjaviah]

@ ahhh I see! No, I don’t have any extra room nor the funds 😅 Hopefully, in the near future. Thanks