Minn Kota foot control repair

[@bandgadventures4796]

Just found this video. ABSOLUTELY GREAT. Had a problem for years causing increased aggravation. FIXED in 15 minutes. THANKS FOR THIS INSTRUCTION.

[@emileo404]

Yes!, My trolling foot control is slightly different from yours and I had to take off the control slide and slip larger size of cardboard from the opposite side of the circuit board where you lifted but it worked great and now it operates as it should. Thank you so much!!

[@cbrady5375]

Wow! My unit was a slightly different configuration, but I was able to get a piece of cardboard between the base and the board and now I'm back in business. Thankyou.

[@troutking213]

You’re a genius. I had an issue with the middle button that switches the motor on and off while using momentary mode. Cut a piece of thin cardboard, slipped it under the circuit board, and it works better than it ever has. Thanks so much for the tip!

[@Hunteroo4]

Thank you so much! Easy fix that worked like a charm and saved me from spending $100+ on a new pedal!

[@HoffnerPrecision]

Thank you!! Saved me $110. Worked for the steering and momentary on contacts.

[@jimbodnar3920]

Thanks Capt. Jack worked most excellently! You get an A+

[@michelevershowske6823]

just did this fix on my foot peddle. worked great , thank you!!!

[@dennisoneill1126]

That fixed it! I used tape on either side of the paper to "waterproof" it. Thanks!

[@daveschwab1887]

Thanks Jack, it worked perfectly after your instruction.

[@billdixon4489]

Thank you very much for the advice it is great fully appreciated. I used a piece of an old credit card and it worked. Thank You so much for your advice

[@ericgibson5370]

A little bit of masking tape to hold the 3 springs in place before you turn it over works great.

[@stevemudre2924]

Fixed my problem as advertised. I had to put small pieces of business card in 2 places. One under the on/off momentary switch too.

[@nbruner111]

It worked...no I can turn in both ways... thanks a mil

[@BirgitJones]

Hi, Captain Jack, good to see ya!

[@ShinerSam]

I can't wait for my trolling motor to quit on me 😂

[@melissaanne9235]

Worked 100%, thanks for the video

[@jdmhum]

Worked for me, thanks so much!

[@specfever2]

About to try this , but curious how to clean the area. Mine is filled with dust and grit that has built up and been wetted. Not sure what exactly you put the cardboard between...

[@glennbawbcanada6391]

Yep just as slick as that Thank you sir👏

[@eliallen01]

Great simple fix.

[@edwardcason9512]

Edward L. Cason😀 A great video , it saved me a lot of money. Just try it

[@Outdoorjunkie]

Will that foot pedal replace the new Terrova pedal? I absolutely hate that pedal !

[@jaggerduff6974]

It's the one and only

[@scottstubbs9913]

Thank You for this Video!!

[@howd8043]

I have the same pedal and some how it got stuck on high speed. Even when I put it on zero it still runs on high. Any ideas? Never experienced anything like it.

[@brianbranstetter4574]

Would that trick work on a ultrex ipilot

[@bandgadventures4796]

PERFECT!!!!!!!!!!!!!!

[@jamesbaucom9538]

Will this work on a foot control on the maxxium pro with 80 lb. Thrust?

[@captainjacksoutsidethebox7320]

Yes it should

[@rayminthecat]

i don't have any cardboard do you or anyone know where i can buy some!