No video

Mistakes to AVOID | Automatic transmission REBUILD

  Рет қаралды 570

Sweeney Off-Road

Sweeney Off-Road

Күн бұрын

Transmission issue solved: 4L60E. In this video I share a hard learned lesson that I wish would have been given to me early on in my build.
#4l60e #transmission #jeep

Пікірлер: 7
@cyndisoo
@cyndisoo Ай бұрын
Keepin' it real, Bub 💯❤️😍
@tomhubbard353
@tomhubbard353 Жыл бұрын
Yes an automatic transmission must be checked with the engine running and at operating temperature. If it is cold like after you serviced it and just re-filled it, I get it in the "add" zone probably a half quart low when cold. , engine running. Then get it warmed up on a test drive and top it off as needed. Make sure you check what ever automatic trans according to what the mfg says IE in neutral or in park, engine running and warmed up. The 32RH in my 99 TJ must be in neutral so the pump is actually circulating fluid where it does not in park(It reads over full in park). I have heard there is a mod to change that in the valve body if one feels the need. I have no idea about the 4L60 but when I finally get to my LS swap, I will need to figure it out since I plan to run one LOL. I am also a big fan of dumping any paper gasket when possible and using RTV alone. I found that putting a thin "coat" like paper thin on one side and letting it skin over/dry then apply your normal bead to the other part really works well. I believe instead of it all squishing out, it stays and flattens almost like an O ring does.
@swavacadoo
@swavacadoo Жыл бұрын
yay! no more drippy drip! It's cool to see you learning along the way. Looking forward to more vids, hopefully no more pulling the transmission though!
@jamesgeorge4874
@jamesgeorge4874 Жыл бұрын
A contaminated MAF sensor wiil under report load, causing the PCM to reduce line pressure, which is also good for killing 3/4 clutches in a 4L60E, K&N has killed more 4L60's than you can shake a stick at....
@sweeneyoffroad
@sweeneyoffroad Жыл бұрын
This is good info! Thanks for sharing!
@vicgustafson8514
@vicgustafson8514 Жыл бұрын
You should fill the converter with fluid before you install it into the transmission. Great info on the dipstick length. I wonder if the same measurement applies with the engine oil pan?
@sweeneyoffroad
@sweeneyoffroad Жыл бұрын
Yeah, I filled it off camera. Good advice for others though! And I wonder. I worry less about the engine having too much oil though, I don’t think it is as harmful
Salvage Yard to Trussed in 24 Hours - 8.8 Truss Kit Barnes 4WD
7:58
Sweeney Off-Road
Рет қаралды 1 М.
How an Automatic Transmission Works (RWD)
19:49
speedkar99
Рет қаралды 340 М.
Box jumping challenge, who stepped on the trap? #FunnyFamily #PartyGames
00:31
Family Games Media
Рет қаралды 31 МЛН
If Barbie came to life! 💝
00:37
Meow-some! Reacts
Рет қаралды 61 МЛН
What’s Wrong with My LS Swapped Wrangler Now?
7:56
Sweeney Off-Road
Рет қаралды 1 М.
Racing driver's stick shift tips for everyday driving
17:31
Casey the Car Guy
Рет қаралды 3,7 МЛН
Wrangler YJ: Part 1
10:03
Dillon Coleman
Рет қаралды 2,7 М.
How to Choose Your Axle Gear Ratio
19:15
BleepinJeep
Рет қаралды 1,6 МЛН
How to Replace a Transmission (Full DIY Guide)
28:24
ChrisFix
Рет қаралды 8 МЛН
4L60e to 4L80e Swap - Installing a 4L80e Transmission on a 4X4
22:32
Jeep Wrangler YJ | Salvage Yard Front Seats
13:45
Sweeney Off-Road
Рет қаралды 8 М.
Drag Racing Whistlindiesel's 1,500hp General Lee! (HUGE wheelie)
24:18
Cleetus McFarland
Рет қаралды 1,7 МЛН