Mixture and Eurlerian Multiphase flow model, Ansys Fluent Tutorial 14

[@parultyagi8461]

Good presentation, how did you decide over Currant number 40? Also you did not show BCs after selecting Eulerian model

[@muhamadfarisqusyairi7477]

May i know why you are using k-epsilon instead of laminar flow for the models?

[@Superslemmet]

How would you do the inlets and outlets if water enters from the top and side, and exited at the bottom, but air bubbles entered at the bottom and exited at the side and/or top (so the opposite direction)? In my case I have what is essentially a tee junction where a packed bed of solids enters from the top and exits at the bottom, but gas enters from the top and bottom and exits at the side (the solids cannot pass through the side in/outlet). It seems like fluent really done not like boundaries that are both inlets and outlets at the same time.

[@raghuramswaroop810]

Informative video.

[@andyyii]

Hi. I'm working with the simulation of water absorption with silica gel in Fluent. Can you come out with a introductory tutorial video on simulating the absorption of water vapor in air (multiphase) with Euler-Euler approach with the use of porous medium of silica gel? Thanks~

[@richardekpedekumo7091]

Can I have the Geometry and Mesh for this video please

[@qurramzeshansyed5445]

Hi, after making the sketch have you selected surfaces from the sketches and also i am getting a problem while giving flow rate weighting (i am not getting the option to enter flow rate weighing instead i am getting the same option as for inlet velocity)

[@mayurpatil6249]

kzbin.info/www/bejne/hHetkmttd9mAhrc

[@kakicoco13]

Can this method be adapted to simulate humid airflow ?

[@hamanisofiane7272]

can we use Euler-Euler model to simulation periodic open flow?

[@monikayadav6746]

# Divergence detected in AMG solver: y-momentum -> Increasing relaxation sweeps! # You may try the enhanced divergence recovery with (rpsetvar 'amg/protective-enhanced? #t) Error: Divergence detected in AMG solver: y-momentum Error: Divergence detected in AMG solver: y-momentum Error Object: #f i followed each step but while running the calculation, after 10 iterations it stopped and showed this error.. kindly help.

[@mayurpatil6249]

kzbin.info/www/bejne/hHetkmttd9mAhrc

[@ibraheemlazm3692]

السلام عليكم أستاذ اني طالب من العراق ارجو المساعده أحتاج إضافة مادة nanoparticles إلى مواد متغيرة الطور مثل شمع البرفين paraffin wax علماً أني اعرف كيف يتغير طور المادة ولكن لا اعرف كيف اضيف مادة ال nanoparticles إلى شمع البرفين ولكم مني فائق الاحترام

[@hajartaheri8013]

Could you please send me your defined geometry???????? I really need it

[@mayurpatil6249]

kzbin.info/www/bejne/hHetkmttd9mAhrc This channel help you

[@ahmadajsdal5293]

Bra jobbat