MODS REVIEW! All The Mods on my Ford Fusion! (Part 2)

[@vononthemoon]

I watch this video every time I need a refresher for the fusion 😂

[@Rick_Schott]

Thanks for posting this *after* I got my trunk trim piece and wiring harness on order for my 18 👍

[@sharpdresser8764]

The roof wrapped vinyl link is broken is there any other links ? And wat kind of spray paint or any paint and tools u use to paint the interior black and white like that ? And how much would u say u spend for all those mods ?

[@p.l.fanning3447]

Man I miss my '17 FFS... Traded it in a few months ago for a 2020 Scatpack Charger. Man I love cars... 😎 #staysafe

[@enriquebarrios7015]

How’s the scat holding up ?

[@RC-rg3vz]

From 445 subs to 4K bro! Fucking fantastic! KZbin “Ford Fusion mods and first two videos belong to you! You’re hyping me up to slowly put out videos of my car and progress

[@DitoCardona]

Trying my best! Lol thanks man, I remember that comment by the way! Appreciate you sticking around!

[@RC-rg3vz]

@@DitoCardona keep at it bro and mark my words you’ll one day have 1mil subs just keep being consistent and keep up the hard work! It’s an honor to be here from the beginning!

[@peterlee6745]

ive a white Mondeo in Uk Wheels were Black. But it looked all Tyre .SO done them Sliver Brings out the Wheel More Great Vid

[@mikecarrano4281]

What was the brand of the paint you used for the headliner and pillars? Just bought a 15 Fusion and im trying to make it all black on the inside. Also how did you paint the trimming on the center console and doors? I watched the video but I don't remember seeing it be done. thank you!!

[@petertalaverasr.7580]

Videos are great brother… I know you been asked 1000 times.. Where can I find and whats the parts number for that rear valance if Im converting from single to dual exhaust

[@ronjlwhite8058]

You can remove the side covers from the stock tails with a T10 bit. there are 3 tabs and the 2 screws that hold it in place.

[@BreakingElegance]

Which headlights do you recommend? what i h8 about the new fusions is that stupid shift knob crap

[@erickmacharia1055]

man, the links to the headlights are not working.any new links? the angel eye lights look great!

[@alexanderpeltz7871]

I have a 2019 fusion that I have been wanting to do some upgrades on but I have found that it’s easier to find parts for the older fusions like yours. I will definitely be doing the headlights and the grille. Love the videos and keep up the good work!

[@Darkstar18773]

I have 2017 and did a bunch of upgrades. But I don’t think those lights fit the 2019

[@jasonvantorre]

@@Darkstar18773 they do make that style for the 17-20. Chinese made of course but they are available on eBay for about $1000 shipped

[@Plague_Rat778]

@@Darkstar18773 idk if you’ll see this but what have you done? I just got a ‘17 and I’m not sure if I’m looking in the wrong spot, but I can’t find much.

[@LanceRipplinger]

I can’t wait to build mine

[@zachtravers]

Awesome ideas! I just got my 4th Fusion, a 2019 Titanium and I'm looking for things to do to it. One of my favorite small upgrades I did to my 2015 and I plan to do to my 2019 is swapping the turn and wiper stalks for Lincoln ones. I got them new from Ford for a 2018 Continental and they look and feel so much more premium.

[@DitoCardona]

4th?? Thats awesome man! Congrats! Well that's really cool, making it more immersive to your liking!

[@talihatasoy9244]

@@DitoCardona hi brother im want bumber insert where can I find? Thanks

[@geneadlam2690]

Hi how much for the items love too get them over here please let me know 😊 ☺

[@fredmartinez8154]

Looks really nice I just a 2017 hybrid but would like to do the tail lights and the spoiler but couldn’t find them any ideas on where to

[@droppy2692]

Thank you for this amazing video as always !

[@DitoCardona]

Happy to help!

[@droppy2692]

@@DitoCardona it more than helping bro It’s true passion for your car and more interesting than BMW / or japan car stuff we found on KZbin I sended you a e mail about mine btw

[@daltonvarner1395]

could you do a grill change video i’m wanting to put a gloss black honeycomb grill on my 18 titanium and how did you change your screen setup on the inside?

[@daltonvarner1395]

for the regular screen and dash

[@DitoCardona]

I'm planning something for sure, and the screen is the factory touchscreen

[@JD-ym2hg]

Please do a tutorial on the footwell lights

[@savagegamer2344]

Could you post the link to the trunk trim portion i haven’t been able to find that exact part anywhere so far, so a link would be very very helpful, I also know I would need to do something with the wiring harness, but what is that and what’s it do/ why should I need it since I have a 2019? because i want to get the mondeo taillights, but want to figure out the logistics before purchasing.

[@markthompson1301]

I wonder if he thought about putting a carbon fictional scoop on the hood

[@NerfMaster28]

Hey Dito Cardona, Love the video I own a 2013 Ford Fusion SE myself and I was wondering if you can make a video on how you wired your Govee light to your car. I would love to get some for mine but can't find any hardwire kit out there for it. I think another cool idea if your fans have questions is have a Discord server for your channel/car. Can't wait to see more Fusion Videos Thank You Kevin Partridge

[@DitoCardona]

I’ll work on an install video! And I don’t think I have enough for a discord just yet but I’ll do my best to keep as much information in the videos and descriptions as possible 👍🏼

[@NerfMaster28]

@@DitoCardona Ah ok, I was wondering do you have discord account so I can add/message you about some stuff? Love your content btw! 🙂👍🏻

[@SwoonDawg]

I've looked and couldn't find anything. Do you by chance, know if the tail lights will fit in a 2018?

[@jermainefudge5379]

Love your videos I wish I owned your fusion 😒❤️I love it

[@carly20]

Do you have a video on you changed the radio and the brand name

[@jamesbwrader1]

Looking at the pricing on eBay for the headlights, 600 + 300 shipping and handling... ummm time to start saving 😂

[@IanpradoBT]

Hey man you are a huge inspiration for my fusion can I get some links to where you got the parts

[@javabeansmusic3098]

do you know where to buy sync 2? my 16 fusion has the 4 inch touch screen and I want to upgrade it

[@MarceloAVillegas]

Great video!!!! Could you show us the reverse lights on the taillights in a short clip?

[@DitoCardona]

Sure! I’ll throw in a clip in a future video 👍🏼

[@MarceloAVillegas]

@@DitoCardona thanks!!

[@MarkMccoy-yt5qv]

I have a 2011 sport fusion will these mods fit that car?

[@melvinbarber579]

Morning can you give me an Part number anything to where an how I can get the rear sport valance?

[@geneadlam2690]

The back lights

[@luigi11yt]

I have a fusion titanium 2017 do the front lights will fit my car

[@itsterpsfan6010]

Hey I have the same headlights in my ‘13 titanium and I was wondering if you knew if the turn signal bulbs could be replaced? Or if you have to buy a whole new set of them

[@DitoCardona]

They should be able to be replaced, I don’t have too much info on them but I’ve seen some rgb retrofits on them so can be done

[@MalachaiWalsh-ri3pc]

Link for the headlights and tail lights??

[@LucidGhostYT]

Where did you have your exhaust done, and how much was it? I want to do something similar and I'm in the Dallas area too. Just grabbed a 2016 SE with the 1.5 turbo.

[@DitoCardona]

It was a little place called Lake June Tire Shop, small place on the corner of the road, if I remember correctly it was around $200

[@LucidGhostYT]

@@DitoCardona Thanks for the info! I'll definitely keep them in mind. Which engine do you have? I've got the 1.5 Turbo so I'm still on the fence about the exhaust because I'm not sure if I'll get that raspy purr I'm looking for. I had the 2.4L Tigershark on my Chrysler 200 and she sounded absolutely monstrous with a muffler/res delete. I'm hoping that even though it's a smaller engine that the 1.5L will sound throaty too.

[@omandsr]

It looks like we live fairly close to each other if you ever want to sell the rims please let me know I would be interested on them

[@DevinKeller1]

Bro I think you should top all this off with caliper covers 👀

[@DitoCardona]

I’ve got some ideas!

[@Dalt634]

I have a 20 Fusion & the headlights have dark spots no matter which bulbs I put in them. They are the projector . I installed LED’s but still have the dark spots but at least they’re brighter so I can somewhat see better. Any thoughts???

[@jamesballard6564]

I have the same model year. Projector beams (fusion 2020) are meant to be replaced as a unit only. This is a fundamental characteristic of projection beams. As for blind spots... I see none. The beam spread is limited by the narrow design.

[@Rick_Schott]

Spoiler was out of stock when I was looking (still is) so I got one that bolts on but has no LED. Any thoughts of chrome delete around the windows? I got a kit but need to set aside some time.

[@DitoCardona]

Sorry man, I have no power/info on whether they're in stock or not but I at least wanna make sure they're accessible to you guys for when they do restock. I am looking to do chrome delete, its just not at the forefront of the list for now

[@Rick_Schott]

@@DitoCardona all good, I lack patience or I would have waited a while. The one I ended up with looks similar just lacks the extra brake light function. Tails and brakes should be going on Tuesday!

[@ALFREAKALOT]

Bring a video on the footlights plzz

[@Potts22bc4l]

Is anybody aware of the RLV part listed in the description is compatible with the 2020 SE?? I am trying to convert to a dual exit exhaust system myself.

[@johnathanruiz-pineda9610]

Curious: I have 16 Ford Fusion Titanium, recently the engine needs to be replaced and now I’m working myself to get a new engine, but I’m wondering: can a Hellcat engine fit in a fusion?

[@DitoCardona]

Most engine swaps are doable it’s just a matter of money, time and effort. It’d be a lot of custom fabrication to get it to fit as well as extra money and effort to get it to function properly on the fusions platform.

[@johnathanruiz-pineda9610]

@@DitoCardona has anyone done it so far? I figured at least one of those fusions had it done.

[@zachg2081]

can you link where to get the trim piece at 5:29 , also do you know of anyone that has videos of installing the trim pieces onto a titanium

[@DitoCardona]

That piece is stock on non-titaniums so it should be pretty easy to find on eBay

[@zachg2081]

@@DitoCardona is it essentially plug and play per say?

[@taylor488]

I want RGB halos soo bad but I know taking apart the headlights will be a pain🤦‍♂️

[@droppy2692]

I throughly thinking that too but in fact it come pretty easy with some trim tool The pain is piercings those hole and fit the light on… huge Time killer here.

[@DitoCardona]

Well whatever you decide, just know of everything on the car it’s probably top 3 for me!

[@shinobisage1720]

ikr

[@tpza8672]

If any one interested in buying those taillights I suggest buying them on Amazon is cheaper then eBay

[@dylanstafford8177]

Has anyone tried this an been successful with newer models? I have a 2019 and not sure if I should get them

[@w.w.w.3875]

Fort 2019 years??

[@artempetrosyan3486]

hello brother, where to buy such a spoiler

[@mountainmew1692]

Link for spoiler: www.ebay.com/itm/392248994663 Links for all of the parts that were bought are in the description if you wanted to look at something else too!

[@DHKKOBE]

I was a get a fusion but for cheap

[@floranove4828]

Hello Dito Cardona! This is Nove from AISKITS, I watched your channel it’s really exciting and impressive. This is a newly launched LED headlight! You can see this LED headlight, is not cool？it is our latest development of a product! In the United States, there are many classic cars, they are our closest partners! Now they may need some upgrades to accompany us better. Replacing and upgrading our headlights does more than making driving safer. They improve the look of your vehicle as well as its performance. LED bulbs have a lower power pull on your vehicle’s battery and system. They also give our vehicle a fresh and new feel with bright white light. I was wondering if you could do a share for it on your KZbin： • Introduction • Overview of features • Actual driving footage with the bulbs • Amazon link on the description for viewers interested in buying the product." Please let me know if this is OK with you. Really looking forward to working with you. Best wish, Nove

[@blakeverken6907]

2020 headlights aren’t available anymore? anything else you can suggest?

[@DitoCardona]

I found these on there after searching www.ebay.com/itm/202401559997?fits=Year%3A2017%7CModel%3AFusion&hash=item2f2012b5bd:g:G3EAAOSwVVpbcXWs www.ebay.com/itm/402585993379?hash=item5dbbfec0a3:g:K34AAOSwnA9fxg8y I don't have a 2017+ so I don't have a point of reference but these are listed for those