MOORING WINCH BRAKE HOLDING TEST

[@Kumar-zb6jf]

Clearly explained, finally understood after clearing CL IV😁

[@shailendranautiyal6310]

not fully explained . in case brake is holding till given pressure then how to get rendering point... ,,,

[@ravijaiswar6195]

Bhai ...abhi Jo aapne btaya end main ek marking agar change nahi Hui within 1 min...means wo 80% set sahi hai ...but phir Hume break ko dheere dheere release bhi karna hota hai na ...kyunki jab hum release karenge toh ek point pe wo render karega ...n phir wo hum Mark karenge on break spindle .....so that while mooring ops crew n off knows that once the break has been tight to this point the break is applied properly .... Can u just confirm ??

[@bobbydiwakar1291]

Your right, Mr.Ravi Jaiswar

[@vishalkumar-fl2pq]

What is the use of warpend present in the morring winches?

[@capt.sarvesh]

vishal kr warpend kya Hota hai bhai...... Mooring winches k fig me label krke dikha sakte Ho.... Tab Batau

[@vishalkumar-fl2pq]

Its a small drum present after the cluth,

[@capt.sarvesh]

Achha ok..... U r talking about warping drum..... The warp end acts like a locking device, which prevents the rope from sliding off the barrel when pulled excessively. Warp end is extremely important for moving the ship along the berth for alignment purposes. This is done by fastening one end of the ropes or wires to the bollards on the shore and the other end around the warp end of the winch.

[@sahed278]

how to load test winch

[@Sailor04shan]

Sarvesh can u make out by looking at ur break liner that it is damaged? Thanks

[@capt.sarvesh]

Shanty. R Wear & tear se pta chalta hai...... If 50% damaged then we have to change it

[@jesalthakkar4056]

Can you show that pressure calculation on next page of your video?

[@capt.sarvesh]

Yes I can show but it is not required for us and it is out of our syllabus.... Calculation is only for technical people

[@narindersingh9068]

What is ship design MBL And LBDF

[@samratthawani94]

this is wrong as per meg4 we use SDMBL Not LineMBL

[@akhil172]

thanks

[@vishantsaini3372]

Thanks brother 👍👍 nice explanation

[@shardul52]

ty

[@nithin367]

Ocimf requirements is is test break rendering test not break holding test. Dont spread wrong information

[@capt.sarvesh]

Ok my frnd, you tell me what is the difference between the two...??

[@nithin367]

@@capt.sarvesh ropes are orderd bais sdmbl.ropes mbl can be 5% above or less than sdmbl. Also in your video you are testing break holding test which is incorrect. Winch break is always tested for rendering not for holding.

[@capt.sarvesh]

What you said is correct, that ropes are ordered as per sdmbl. But what you don't know is that this video is too old and earlier break holding test is carried out, but now a days they changed the name to brake rendering test. Both has the same test and same purpose. I think this time I made to clear your confusion.

[@sangwankapil]

Excellent

[@VinothKumarThangarasu]

Atleast add english subtitles...