THIS IS ME PRACTICING USING AN OSCILLOSCOPE, I WILL MAKE MORE VIDEOS TO COVER MY PROGRESS AS I LEARN THE USE OF OSCILLOSCOPE. BRAKEBOSSLLC@GMAIL.COM
Пікірлер: 10
@MechanicTechnicianRepair Жыл бұрын
Exselente diagnosis master mui bueno master
@advancedleveldiagnostics Жыл бұрын
Great video, Thanks! What were your settings on the relative compression test, something seemed off with your waveform?
@brakeboss Жыл бұрын
I noticed that as i was editing that there is that small hump, i think my mistake was not using 600 amps but i had it set on 200 amps and that skewed the image, also i didnt hold the throttle at WOT because i disconnected fuel pump but im not sure if that something that needs to be done on these.
@advancedleveldiagnostics Жыл бұрын
@@brakeboss You do not need to hold the throttle if you disconnect fuel pump, holding the throttle just disables the injectors on most domestic vehicles eliminating the need to disconnect fuel pump.
@brakeboss Жыл бұрын
Thats what i thought also, but wondering why i got that extra hump, i have to practice more with it. Working at MB dealer we never really used scopes, even when we got training, i guess the oem scan tools just gave much more info to make diagnosis faster, but now rhat im mobile i have been missing out on the scope world
@advancedleveldiagnostics Жыл бұрын
@@brakeboss I Don't know what that extra hump is, I'm assuming it's something with the scope & not the vehicle. Just keep on practicing you're doing great! 😄
@brakeboss Жыл бұрын
Thank you buddy
@briansilva91209 ай бұрын
How did you know the blower motor was working good? Did you have the specs on the blower motor as to how much amps it should be on each settings? Just curious I’m also learning. Great video by the way keep it up 👍🏼
@brakeboss9 ай бұрын
This was a good known vehicle, the blower motor warked good so i was more concentrating on the change rather than the motor itself, different cars may use different types of resistors to control speed so its case by case basis, as long as there is change when the speed is changed then the resistor is working as designed.
@briansilva91209 ай бұрын
@@brakeboss I understand but I think it will make more sense on knowing what the blower motor should be to use as a reference point. But point well taken as I mention I’m also learning. 👍🏼