Interesting. I just got my CAN Shield and I was testing it on my Jeep. I couldn't seem to get any results. I was avoiding using my wife’s Toyota so I didn't screw it up but decided to give it a try and got a flood of frames in the output. This video seems to have answered the why. Thanks for the video!!! Your videos are a great source of information!
@TheMohammadsen8 ай бұрын
You are so awesome man. I really appreciate it.
@KarlKristianMoeng8 ай бұрын
Very good video!
@fredimachadonet8 ай бұрын
It would be awesome if you could create a tutorial on how to use your board and ESP32 to open a garage with a button on a Tesla steering wheel. Thanks for your content!
@MrDIYca8 ай бұрын
yes, that is coming up next :)
@juliotroche38355 ай бұрын
awesome information. I'm definitely getting that esp32. 1 question does that can information come from the ecu? in my case I would like to connect it to my motorcycle.
@mikesfarmmikesfarm39778 ай бұрын
I have seen your webserial vid. Have you thought about a universal project to connect a existing nano (or any arduino) project that will connect to its serial port and a esp8266 or esp32 reads nano serial port and retransmits it via webserial. It can be used to temporarily troubleshoot/instrument a simple project that does not need full time webserial.
@CubbyTech8 ай бұрын
A vehicle manual won't show how to connect to the CAN bus. OBDII is not a protocol, and the CAN bus lives on the OBDII port.
@timbockhop72234 ай бұрын
@MrDIY thanks for your tutorials! Do you see any chance to control a car using CAN bus / OBD II so it could drive itself? Let's say, go into drive mode, release the brakes and go forward very slow and then brake and stop again...
@MrDIYca4 ай бұрын
You might want to check a project called OpenPilot
@timbockhop72234 ай бұрын
@@MrDIYca thx so much. Will have a look.
@langtupt8 ай бұрын
maybe controller to KIA Car?
@MrJimmyPenguin6 ай бұрын
I sent you an email, on a project I'm attempting with your OBD boards, any insight would be a life saver.