Vertical Mill 3/8" Tool Holder

[@TedRoza]

G'day Lee. Nice little flycutter, which worked out well. Could also double up as an oil groove ring cutter on a smaller tool. Many years ago I used similar flycutters when modifying chambers on heads for bigger valves. The main difference was the tool had 3 sizes. The top few inches was about 3/8" OD The centre varied on the tool steel cutter, with a side grub screw, & the bottom which was a minimun of about 6" in lenght was the ID of the valve guide for stabilisation. Worked well on cast iron as well as alloy.

[@scottjones7279]

Your computer skills worked well on that surface grinder

[@jimdean7335]

Nice work. Happy New Year, looking forward to more content in 2024.

[@AmateurRedneckWorkshop]

That is a handy tool you never have too many variations. Well done. Thanks for the video keep on keeping on.

[@mrc1539]

👍 ! Shouldn’t the leading edge of the cutting tool be on the center line of the holder ? It seem to cut very good , but I was curious if it should cut like a fly cutter.

[@Stefan_Boerjesson]

Thank You for yet another interesting and inspiring video. One request is to add some more gain to the audio. 100% still sounds like whispering here.

[@clifeddens1658]

Very impressive.

[@CraigLYoung]

Thanks for sharing 👍

[@pauldehaan3574]

Thanks for sharing

[@alanremington8500]

Nice job. I have a question about the position of the cutting edge with reference to the center-line. Is it set up like a fly cutter?

[@honeycuttracing]

Think either wasn't on center when drilling that center bolt hole or the head of the bolt bent 🤔 you can really see it at 22:22, rest of piece is centered but bolt head is wobbling like crazy

[@jsteifel]

I think you should have offset your slot so that the cutting edge is on center, not center the HSS.

[@honeycuttracing]

Believe you are right but he would have been forced to use larger diameter stock to have enough meat 🍖 😉 to have his 2nd bolt

[@nigelharding9223]

HI Mr lee most of your videos the sound is very quiet just to let you know. all the best for the new year from the UK

[@jamesbowenjr.3022]

I liked the video and will be a handy tool. I sent you an email in reference to the surface grinder and I think you are heading in the direction to my suggestion for your future projects. Can't wait to see if I'm correct.