Respected sir I have a problem sometimes occur , plz help me out.... Problem is....when i put a flange on a flanged valve , and flanged "mating option" doesnt apear so the pipe size reduces itself.. So why is it reduced itself?
@mehmet22476 жыл бұрын
Hello, could you make a video about preparing drawing from this assembly? What kind of topics are there that we need to pay attention? Thank you.
@davidgibson85235 жыл бұрын
why do you leave a gap between the red pipe and valve?
@jimstieben28857 жыл бұрын
your music is so annoying I had to leave your videos. I have found other videos of yours and it is nearly impossible to watch to the end.
@Designhubindia7 жыл бұрын
+Jim Stieben thanks for your precious feedback, next video we will try to remove . Actually most of the video record on the manufaring site .Ao there is no chance to put the voice. So we will try to put some soft music in video.
@K12AMAl6 жыл бұрын
very bed because don't say where it is use command
@Designhubindia6 жыл бұрын
+Kamal Hossain watch other video..These all little bit advance.