Mustang power window not going down. GEM bypass 1999 2000 2001 2002 2003 2004

[@fullrangehemp903]

You, my friend are a genius! 2003 V6 Mustang convertible drivers power window was not working (up or down) - so it failed State Inspection. My switch cluster & my window regulator (motor) were fine, so I was completely stumped. I bypassed the wires exactly as per your video & now I'm good. Bonus - mine doesn't make a clicking noise despite being direct wired. Thank you so much! Warning for others: 1st verify that your switch & window motor are fine before trying this.

[@jacobswenson]

This was it! I looked FOREVER for the problem… THANK YOU FOR POSTING THIS!!!!! I don’t even have a clicking from under the dash 💪🏼👊🏼👍🏻🤞🏼

[@jonahhall709]

You are the man. I just wiggled the wires on the gem box and my window works again. Thanks

[@NimNum]

I need to try this ! My driver side will not let down !

[@KDBSPORTS_ENT]

​@@NimNumSame here, just stopped working out of nowhere.

[@khalilwhitaker9966]

All i had to do was plug in my little fuse breaker and that fixed it for me

[@ronniejoehinton2727]

Could you tell me where the breaker is for this?

[@xavierdelgado1023]

Did u ever fix your gt ..the gem module. Did u fix it all the right way.. was there a pats problem wgere your car would not start..

[@JohnSadoughi]

Not sure if I understood your question. I did not fix GEM. No start problems.

[@JOHNNYREBEL1976]

@@JohnSadoughi were could I buy a gem for a 2004 mustang gt please let me no thanks

[@JohnSadoughi]

@@JOHNNYREBEL1976 Do not buy from junkyard. Look online for GEM with warranty

[@wenceslaoperez9257]

My windows do not going down. But when I hit the lil motor on the door stars working.. ? Can you Answer the question

[@JohnSadoughi]

I think, if your window goes down very slowly, your motor is probably dying, so I would change the motor. But otherwise it could be something as simple as a bad wire or the connections are loose, which could be fixed by replacing the wire or tightening the connectors on your wire. Or it may be due to bad teeth. In this case you can buy the motor and regulator as one unit assembled together. It is not that easy to replace them. I cut my hand a couple of times and scratched the paint doing so. All that says I'm not a pro, I may be wrong. Move the wires to see if it is a simple fix or not.

[@JohnSadoughi]

One more think, if none of your windows go down, it is an electrical problem with wires. The fact that all windows work only after you hit something has something to do with, again, bad connector or bad wire. None of my 4 windows worked at first due to main supply wire being bad. It is the Blue Wire on the video at the bottom of the switches. You can see a black tape, it is because the original blue wire broke between the door and under the dash. So I cut it and inserted a new wire from under the dash through the rubber housing at hinches of the door to inside the door to the switch. I hope that helps.

[@aguilafloresflores6535]

What is the name of that part that have to replace

[@josuepinal8401]

Mine does the clicking as well but it does not go up

[@WizardKing-Official]

Might check the wires on the window motor. Click means theres power but no connection to the motor. Or the motor is stuck.

[@xavierdelgado1023]

Do u gave you have lights .or doorlocks .

[@codyowen5590]

i have same problem as you no power locks or interior lights

[@codyowen5590]

my passanger window does not work either

[@deadcarnahans1932]

What's with the narrow picture in the center of screen?

[@steven7297]

Anyone can show where the wiring harness for driver side door is ?

[@matthewstatz8434]

I'm confused please help

[@JohnSadoughi]

Read through other comments I left for other people and see if that helps

[@chriscamp5190]

My problem is the window wont do shit idk

[@JohnSadoughi]

As I explained to the other guy, it may be due to a broken wire inside if the door or near the hinches. If none of windows work it is the negative wire, if only 1 window does not work it may be the positive wire or the switch or the GEM. Hard to tell. You must trouble shoot.

[@chriscamp5190]

,i want to straight wire it how do i do that and use the window switch as the toggle switch but still keep all the other wires connected because i checked the wires coming from the door to the dash and found 4 wires that i had to reconnect because they were cut into idk that was always been like that since ive had the car but everything works but my driver door window no power at all idk the motor gears may be in a bind

[@JohnSadoughi]

@@chriscamp5190 so you can't just straight wire using the same switch, because all the switches on driver side have a common wire, I think it is the negative. You can use a different switch. A 2 sided one with straight wire, but then I highly recommend to add a fuse to it. But first find out if your window motor is good. Disconnect the motor from the 2 wires and directly connect them to battery for a couple of seconds, then turn the wires around and connect them again. If it does not go up and down, you need a new motor and regulator. Then check to make sure that all fuses are in fact. If someone rewired it before, they may have added a fuse that is now burnt.

[@chriscamp5190]

Sovwhat your sayingbis to check thevmotor is to unplug thecwindow control switch and run the two wires or the one that is hot directly tobthe battery and if it moves then that meens that my motor is bad seems like that would meen that every thing othen the motor isnt working correctly You know its strange because it worked fine one munute then i get in the car and try to roll down my window and nothing no current pull or nothing on that particular button everything else works could it be possibly my ignition switch because ive been restoring that car and i pulled the streering wheel and all the the pkastic trim peaces off to paint them and had a bit of a issue getting thatrim peace the goes on the switch off and i broke it but was able to put it back on and it works its a lil loose but works

[@JohnSadoughi]

@@chriscamp5190 if everything else connected to your steering switch works, for example the radio, then it is not that. If you direct wire window from battery and the motor works, you have electrical (wiring problem). It could be the common negative, or positive, or a fuse or the switches. You need to buy a continuity tester to test all of that. Just to simply find out, if for example there is a breakage in your wire coming from under the dash into your door. You could also buy the whole door from junkyard and replace all the wires. But it is a fuse, that would not help. Check fuses first.