my Ford 8n tractor plow setup. I hope that it helps everyone out

[@robertallen6848]

Great job Mr awesome you rock

[@greggtidd4816]

Thank you. I appreciate that

[@tonymckeage1028]

Great Setup very clever

[@friik100]

Very well made plow, thank you for sharing! I can see the plow undercarriage frame (the white part) is mounted between rear mounting points and front axle. I am not familiar with those tractors, but is that front axle not pivoting on center pin? Or in this case is frame locking the pivoting up and its now locked hard-axle? Browsing youtube videos to get ideas how to make frontal plow for my tractor, so getting some ideas here as well. :) Thanks!

[@alm7707]

something is bending because the front axle does pivot. but doesn't likely create a problem

[@friik100]

@@alm7707 What I figured as well, if it causes problem, some weld on ball joints could help out in rear and front mounts.

[@Dinkys824]

I'm going to make one for my 52 8N thanks for sharing

[@greggtidd4816]

I had so many people who asked me how I did it I had to share it

[@Dinkys824]

@@greggtidd4816 thanks again I have a 6 ft plow and upper frame work off my old Ford ranger that will work just fine

[@johnbauby6612]

You hope it helps everyone out meaning you're going to plow my driveway?

[@greggtidd4816]

No problem, buddy