Creating and using 3D solid tool in NX (part 1)

[@chriswis2457]

How did you make that custom ude tool position selection? 🇵🇱

[@parthasarathinayak7202]

Is it possible to create multiple cutting tool & holder library?

[@yea7115]

How can I do holder position setting without UDE application?

[@NCmatic]

Hi It depends how the postprocessor is setup. In case of lathe mode on Okuma we don't use exact B-angle, but registered tool position. That is why UDE was used for that. There are several ways how it can be configured - and you should use it the way as it is specified in your postprocessor.

[@darshanhkdarshu3992]

No write access mesg came

[@nareshpendam7489]

send me 3D model of tool.😇