NCS Expert Coding Out Seat Occupancy Detector For E66

[@bluestack7889]

I tried to do this but chassis error🥲… e87, 120d, it was difficult because I don’t know what ecu, or etc because no e87 profile as I had to use e89… but it doesn’t work. But I did recently TOOLSET32 to reset light counter, no problem but I cannot find it for seat, I know it’s in MRS5 module… It’s just bit challenge to find in toolset32 I think it’s just software issue or lack of files…? Any help? ISTA+ works beautiful, but I need ISTA + P that might work better to disable sensor?

[@heshamessam8042]

Can you use ncs for other modules?

[@bluestack7889]

@@heshamessam8042 the NCS doesn’t work properly as given CHASSIS error then VIN faulty, it’s possible lack of files for e87 (E89) If I reinstalled NCS, the first option was asking me CAS, FRM, NFRM but once it fetch VIN then it just stop, keep giving chassis error. But INPA, ISTA+ all is working perfectly

[@heshamessam8042]

@bluestack7889 with ncs ... try to get vin and fa from other modules ... frm cas

[@bluestack7889]

@@heshamessam8042 Do you mean, F1 (VIN/ZCS/FA) then press F2 (Enter FA) where next appear to choose Chassis, E89, then put VIN number the long one or short numbers (from INPA info or INSTA+) yes? Will this hurt to test it out? As I’m aware wrong input, as the ECU security did block it, as I had to clear the error before I can re-try other methods. Thank you!

[@heshamessam8042]

@@bluestack7889 you shouldn't put vin ... ncs should find it ... can ncs get vin

[@jovanzacevski]

I am new at this. I have E61, cable must be plugged in obd port all the time while doing this ? Thanks

[@heshamessam8042]

Yes

[@MalcolmV8]

Since you exported the fault code to a file to code it out would you ever be able to re-enable it?

[@heshamessam8042]

Yes

[@aliozturk8310]

After this process, will the vehicle shift to the p position when the door is open? and auto p will be active again? Or how can I activate the auto p feature again. thanks.

[@heshamessam8042]

This is not related to that issue ... its related to airbag only

[@aliozturk8310]

@@heshamessam8042 I think I have a problem with seat occupancy and that's why auto p doesn't come into play. can i code it or how can i solve it

[@heshamessam8042]

@@aliozturk8310 i don't understand ...

[@xxbvanxx]

Will passenger airbag still work?

[@heshamessam8042]

yes ...

[@jadertabares8995]

works at E90?

[@heshamessam8042]

Same idea (with ncs expert) ... but may differ a little bit (may be on airbag controller itself not a seat module)

[@jadertabares8995]

@@heshamessam8042 I did code out seat occupancy sensor but after a road test the warning light came back and the fault, what did I do wrong?

[@heshamessam8042]

@@jadertabares8995 disconnect connector .. then code out

[@arttac6865]

mashallah!!!!

[@heshamessam8042]

😀