Nerf Infinus on 3s and KEPT auto loading!!!

Here is a quick overview on my modded Nerf infinus running on 3s and keeping all factory functions! In about an hour and just a few bucks you can run your infinus on 3s. I decided to keep all factory switches and locks in place because I don't use this blaster much.
Link to the voltage converters:
www.amazon.com...
DISCLAIMER!!
All mods you do are at your own risk, as with anything electrical and delicate like the board in the infinus this model should only be prepared by someone with knowledge of low voltage circuits therefore I can not be held liable for damaged caused by your actions as this is only an overview on what I did to my infinus.

[@Sparroh]

The jam door always gets us lol. Great vid, I’m going to try this, I got the worker kit from out of darts.

[@pmm4177]

The mod on this one really made this blaster a ton of fun to use!

[@pmm4177]

I did forget to mention you have to isolate the flywheel motors as well, the flywheel power wires and the Rev trigger have to be removed from the stock board to create the 11.1 v circuit for the flywheels only

[@deafeningcash9744]

Do you have any installation tutorials?

[@domnulpuiut732]

Great mod! I would also like to do this for my son but i cant wrap my head around on where the buck converter goes. Do you have, by any chance, by wiring diagram? Or anything like that? Would be highly appreciated

[@pmm4177]

I dont have a diagram, I will look when I get home and see if I can find you a link

[@domnulpuiut732]

@@pmm4177 man, I had no hope you would answer. You're a gent. Sure thing, whenever you have time, I would be grateful. I even ordered the same buck converters you suggested .lol

[@xydoestuff]

@@pmm4177 any updates on the diagrm?