Papa shows a well hidden secret in some ( mostly Honda) engines that can lead to a no spark situation.
Пікірлер: 18
@neilsreal4 ай бұрын
Great video Papa i never knew that part existed in the plug, i removed it and tried one from another motor and it works now. Thanks so much saved me from ordering a bunch of parts i didn’t need.
@JoseMPerez-dk5gy6 ай бұрын
Thank you Papa You made my day from Fremont Ca.
@philliphall5198 Жыл бұрын
Low oil shut down bad, unplug yellow wire and start it up
@williamallen6934Ай бұрын
I got one that one minute it's got spark then it doesn't it's been inside kept all it's life I don't think it's ever been started.i by passed the kill switch it runs great is it a bad grind on the kill switch?
@user-so9yj1hc9c12 күн бұрын
THAMS PAPA SHOP.!!!!!👍👍🇺🇲🇺🇲👍👍🇺🇲🇺🇲
@ericbliske84856 ай бұрын
Thanks! This is exactly what was wrong with mine! It came apart and when the spark plug was removed all the parts fell out and they didn’t notice! I found the spring in the bottom of the generator! Still looking for the resistor and screw cap!
@philliphall5198 Жыл бұрын
Yep the plug end cover has a resistance in it, that’s other problem that is common also, not AllWAYS the coil unit but bootbad
@oscarvogel21402 ай бұрын
A resistance test would show this right? From the end to a ground?
@snpxox5 ай бұрын
i can certify a chopped ss screw works in place of the resistor!
@user-so9yj1hc9c12 күн бұрын
THANKS PAPA SHOP.!!!!!👍👍🇺🇲🇺🇲👍👍🇺🇲🇺🇲👍👍🇺🇲🇺🇲👍
@paddyschannel2173 ай бұрын
Brilliant advice … you have just answered my query. The small spring and resister just fell out but I wasn’t aware where they came from or what they were 🤷🏻♂️ … unable to find them now so what shall I do?.. can I order the parts? Thanks - Pat in the UK.
@papassawshop32233 ай бұрын
Hi Pat. I've heard of some people cutting a wire connector to the right size that fits in the space that used to be taken up with the resistor and spring. Be sure to remove the plastic covering on the wire connector.
@paddyschannel2173 ай бұрын
@@papassawshop3223 thanks Papa really appreciate the advice pal…. Take care buddy 👍🏻
@mikegalvin4655Ай бұрын
Hi Sir I have power washer with a gc190 I did change the plug and the ing coil still no spark I do not understand my problem any help thank u
@papassawshop3223Ай бұрын
Hi Mike. Thanks for checking in with me on my channel. All things being equal, the spark plug is new and tested good, the new coil is good and the air gap is correct.. try these suggestions: 1st unplug the small wire from the coil, this is the ground wire/kill switch, turn over the engine, still no spark. Check the oil, make sure it's full, then unplug the low oil switch, try Turning over the engine again. Still no spark, thoroughly clean the flywheel magnets and make sure the flywheel, crankshaft keyway and flywheel line up. Still no spark, replace the coil, again.