NX SOL101 Load Frame Simulation

[@MRsexymexicanMAN]

Helped a lot !!! Thanks

[@ITAIntegratedTradersAcademy]

ขอบคุณมากครับ

[@locdao1706]

Hi, I have a gripper that pick up an object in Motion simulation. Then I use Pre/Post and Loads Transfer to observe in FEM. Basically it's just normal FE model. However, I can't see Reaction forces in the result (I made it once, but I didn't save and the following tries later I can't see it anymore). I already request Output for Force and SPC Force but it still doesn't show. Which can be the possible mistake I made that prevent Reaction force to be plotted? Thank you Loc

[@TheLiddokun]

Excellent

[@АнтонДымов-е6р]

Thx !)

[@siavash2c]

when you applied the force to the coordinate system, how is that point connected to any nodes?

[@FedemDigitalTwins]

If I remember right I used a RBE2 element

[@siavash2c]

@@FedemDigitalTwins Got it. I don't think you showed that step (setting up your FEM) in your video, however, it was very useful. thank you. Can you make a video on formulated loads on a surface?