You dont want to put anything in the motor to block the piston... you can use a 13mm socket on the opposite side to hold the clutch from moving. This will prevent any damage to the piston
@danielpadgett28312 жыл бұрын
You can put a piece of nylon rope in there it wont hurt nothing or like he used a rubber piston stop
@TheJagot6 ай бұрын
Its happen to me. I destroy the conrod.
@itskata3 жыл бұрын
Very professional snd educational work!!! Good job
@tusheeNaydenov3 жыл бұрын
Thank you very much!
@kamerahegyi2813 Жыл бұрын
What about oilpump drive lubricating? Not neccessary?
@tusheeNaydenov Жыл бұрын
yes, it's not necessary, but if you consider putting a little grease it won't hurt
@kamerahegyi2813 Жыл бұрын
@@tusheeNaydenov I am in a dilemma which is better, a clean but dry surface or a dirt trap with greasing.
@patrickfrazer97723 жыл бұрын
Hey there, great video. When I tried this technique it worked to push the tab back, but then sprung right back to where it started. Does it every time and wont click in. Any ideas? Thanks!
@MarkoMarkovic-ux8tu Жыл бұрын
Kako je moguće da se uljna pumpa blokira od piljevine zar nema plastična zaštita sa druge strane