OpenPLC and Arduino Part1.2 : Getting started and first project

[@Rico_707]

You knocked it out of the ballpark with this tutorial. Thank you so much and keep up the awesome work. To automating I go...

[@Deathswitch669]

This is a really nice tutorial, you did a wonderful job of explaining.

[@areejabdelaal4446]

شرح وافي 👌 Great tutorial, thanks

[@LikeVHD]

When I disconnect the Arduino from the computer. Can I still control the leds with buttons?

[@dhanilvharidas377]

please explain about function blocks and their config.

[@vinkobrglez3747]

how to get to local host

[@ajisafebhayor8793]

Pls which arduino is this

[@HappyCoding-i1c]

I used Arduino UNO

[@Lacunaaporia]

Please explain what you did on the breadboard? You kinda just fast-forwarded through it without any explanation.

[@Rico_707]

He connected everything per the schematic on OPENPLC’s website. Each of the pin connections are specific since the program is limited in discrete I/O. Check out the mapping. But usually when you’re putting 5v into an LED, you typically use ~220ohm resistor to protect it from burning out. Nothing crazy from this basic seal in program.

[@prudenciopinzonl8042]

Spanish please