Our KA24DE Nissan 240SX Won't Start After Reassembly - Engine Diagnosis Video

We did A TON of work on the 240SX rental car engine over the last couple months. Basically had the entire engine apart aside from pistons out (and that was very close to happening due to "because we're there" syndrome).

[@pangeaspeed]

Thanks for the video! This saved me after fiddling around for hours trying to get my car to start.

[@flip240]

Love KA videos no matter what the content

[@kevynroberts3412]

Had the saaaaame exact problem. Think my timing might still be off by a tooth but after watching this i know exactly how to figure that out. 🤙🏽

[@tonyt9537]

@6:21 You should match indent on dis to the shaft pin. There is an error on the FSM. Also very tricky when inserting it as it can also jump. What i do is pinch the rotor and when inserting it wiggle left to right a tiny bit while looking at the top bolt sloted hole.

[@OEFarredondo]

Holy cow. I would have parted it out by the end of the compression test lol

[@skibiker18]

its the carhartts that do it for me

[@Saisan281]

So I just bought a 240sx last owner did the head gasket and we’ll let’s say it wouldn’t start after that …. This video was my solution that n toy

[@jamescoleman3527]

I am pulling my cylinder head to send it off. I hate the Ka so much.

[@TheAsdfgh38]

Give it to me pls

[@thebeattee569]

helll yeah bruther

[@kurtlan4636]

I have to replace the PVC Valve(rubber grommets) when I replaced the PVC, is between the PVC and breather separator, the rubber vale was so bad and crumble, most of pieces was fall into the breather separator, I didn't take them out before I replaced the new PVC, This this matter?

[@Natives-cm8yb]

What’s the compression warm now?

[@videoeditor9104]

KA timing is 20 BTDC

[@fabirodriguez7212]

15”*

[@ramonesfreak2010]

@@fabirodriguez7212 FSM states 20 degrees +/- 2

[@TakumiFuji01]

Will chicken man ever be back in this car?

[@strandtype]

Chicken man told me favourite engine is KA24DE