OWL BE BACK! | Longer B1 40W | Art work |

[@jmwetterene7459]

très bon travail bravo et merci

[@keliiwilliams8142]

It would have been nice to see you upload the photos but this is nice!

[@jewijk]

Thanks for watching. Do you mean show some pictures of the end result in my video? Or perhaps I misunderstood and you mean uploaf the design in LightBurn?

[@Ingo.01]

Another nice project! I'm doing 8 layered mandala's at the moment, I see a lot of similarities in our work flow. Looking forward already to see your next project :)

[@jewijk]

Thanks for watching my videos and great to hear you enjoy my content. I've too done some projects with 8 or more layers and these are a lot of fun to do. Did not do any mandala's yet, but have saved a few in my favourites. Really want to do one soon as I think the're pretty cool.

[@bietebouwer]

Great work!

[@jewijk]

Thanks!

[@frchguy]

Yours videos are amazing, good job and well explained! I was wondering , which kind of wood do you use for your laser work ? Do you go to your local DIY and buy standard plywood or do you have a supplier who stocks special laser plywood. I live in France near the Belgium border so not so far from you and I am always looking for a good wood supplier even outside France. Thank you for your work.

[@jewijk]

Thanks for watching and your nice comment! I just buy them at our local DIY store as I do not need too much. Dedicated woodstore might be better priced though. Or buy full sheets if you can transport them. That's also less expensive than buying sheets 122x61cm. I use 3mm plywood like here below, have great results with these (nice and very clean cut) www.karwei.nl/assortiment/timmerplaat-multiplex-122x61-cm-dikte-3-mm/p/B818520

[@jewijk]

@frchguy you're welcome and I will 👍🏻