I block the rear wheels, jack up one front wheel from the lower control arm, remove the wheel, have someone start the car and put into gear, the hub would spin and I used a mechanic's stethoscope with the probe pressed against the steering knuckle listening for a bad bearing. It doesn't load the bearing like driving, but, if the bearing is bad, you can usually hear it. I really enjoy your channel, thank you.
@alltsab Жыл бұрын
Yup that work. Thanks for the tip buddy
@gregntammie Жыл бұрын
Thank you, replacing the bearing on my wife's Escape.
@0987__ Жыл бұрын
Best video on this topic. Thank you
@kprberg4 ай бұрын
A very good tutorial. Excellent job well presented.
@alltsab4 ай бұрын
Thanks 😊
@cd9225 Жыл бұрын
We love you for the repair stuff. Includes the stupid over price kia starter.
@alltsab Жыл бұрын
😂😂😂 I love it. Thanks buddy
@billycdlmfrank20094 ай бұрын
Really good 👍
@777mazzy Жыл бұрын
Super, tego szukałem. Pozdrawiam MF
@AlfredBattle4 ай бұрын
10:57-11:17 Can this assembly be replaced from another vehicle instead of hub removal, bearing press in and out, hub press again? Great content!
@maovi76522 ай бұрын
Yes you could, but it's hard to find whole wheel hub in good condition as last cars was produced late 2019
@guthrieannon79254 ай бұрын
This video was very helpful. Thanks
@alltsab4 ай бұрын
You welcome
@touavang5343 Жыл бұрын
Hi brother when you live l need help with my civic front bearing don’t know which side are bad….
@waylonadams2203 ай бұрын
U da man
@connorcollins2409 Жыл бұрын
Thankyou
@user-jt1xk9ss4t5 ай бұрын
Can you replace broken studs on this vehicle? Would I need to take out the entire hub like shown in the video?
@alltsab5 ай бұрын
I'm not sure, but I think there is a gap you can pull the stud out.
@jamesavery7820 Жыл бұрын
Dude your so the funny asain dude in a comedy movie
@barstoolsandpowertools8617 Жыл бұрын
👍👍👍
@ElAmigoDelMundo99 Жыл бұрын
Txiv ntxawm, koj yog hmoob xeem ab tsi os? Thov koj qhia, puas tau os? Ua tsaug.
@Xero2105 Жыл бұрын
Did you have any issues putting the ABS Sensor back in the slot? I can’t seem to get it to go back in the slot.
@alltsab Жыл бұрын
No problem, may be you miss the abs hole
@twc20031985 Жыл бұрын
On this particular design, you have to have the gap of the snap ring that holds the bearing in lined up with the hole for the abs sensor or else the sensor won't go back in. I have done several like that. Most have the snap ring on the outside and it doesn't matter but these escapes go the other way.
@coopersdetailing30164 ай бұрын
I know this is 9months ago, but the snap ring has to be turned a certain way or the abs sensor hits it.
@sunny75310 ай бұрын
No shop pressed machine for me so I guess plan b is to take to the shop.