Paradox Alarm System PGM Automation Programming Relays

how to use an alarm system pgm with relays to automate processes like automatic aircondition activation.
include wiring and programming for paradox evo192!
👍 temperature sensor link: bit.ly/2nzREBK
🙏 SUBSCRIBE ▶ / @securitytechadvice1981
FOLLOW US ON:
👉 Pinterest:
/ quickoverview
👉 Google+:
plus.google.com/+QuickOvervie...
Song: Jensation - Donuts [NCS Release]
Music provided by NoCopyrightSounds.
Video Link: • Jensation - Donuts | H...

[@tanello2]

The whole idea that a 40 bucks EVOHD security panel can connect to 254 expansion modules and u can build your whole house to run one one security system is just so insane i dont understand why havent every single person who is intrested in home automation done it allready ?

[@MuhammadSaloojee]

Hi, using Babyware software for Paradox alarm systems, If i have an aftermarket Sherlo receiver for aftermarket Sherlotronics remote connected to the evo 192 panel, and i want to turn on /off an area with the remote, what must I assign the zone as? (instant, burgler, etc) I assume I must assign it as 'entry delay '..) but it doesn't work.. Everything is connected properly because it was working (existing installation) but i have to program it again because I reset all programming by mistake.

[@moises.csilvera]

thanks

[@mabiyaya]

Hello brother can I asked? How can I set auto disarmed the mg5050 or Evo192? This is possible Or not.?

[@VLandrew]

Yes use switch key and built in clock

[@glenn169]

Hey there, I wanted to have a light in my house light up when the alarm is armed, is there a pin out on the board that puts out voltage/ signal when it's armed?

[@gudrn]

Hi there. Yes. PGMs are configurable to do that. :)

[@somnangchre6509]

hello brother .u can help me how about set hand phone for SMS in EVO192?

[@wyattoutlaw2370]

SOMNANG CHRE What do you need to know? How to get the iParadox app working. Start by getting yourself a Paradox Ethernet Module (iP150)...and then make sure you have internet connection. Jump on your router and port forward port 10000. If you can get to there ... I’ll talk you through it.

[@johanbarnard8317]

Can anyone please assist me? I want to install a sherlo remote control unit to my Paradox SP65 panel in order to arm and disarm remotely. How do I wire it and how do I do the programming to get it working? The keypad has no LCD. Please help????

[@VLandrew]

Login with software

[@ffytgm]

Any explanation?????