Part 1: Hefty Hoist Dump Kit Measurements

[@landybob8393]

Great video. The other idiots only show when it’s done. Done know the point in that but y’all are awesome

[@desiredkid]

Its a good video, but needs to be updated. The newer kits come with parts which the older ones didn't. The new kits don't have a toggle switch, they have a better updown button control, they also come with a saftey prop, a circuit breaker, rear scissor support braket, and a pump mounting L bracket. I believe it also comes with guide brakets to guide the dump body down. Plus they don't mention this is a power up, gravity down hydraulic motor. The wiring differs. In general it would be nice to see a updated video.

[@Jonathan-bf6nh]

Happy Holidays and New Year this is KI4NRP

[@shawnsavage9015]

Good information!!! How large kit could be used on a 1 1/2 ton truck. (C4500) Chevrolet Kodiak

[@ican8243]

the only tipping gear to use is "Harsch Ind." . You did a great job however, it would be a lot easier to make a sub frame and mount your hinges and hoist to it. Then you can weld a pintle plate to the truck chassis so you can tow safely. We do custom tipping beds on all kinds of trucks 1 tons and up. my only concern no place to have a pintle plate.

[@jeep5330]

i installed this kit and i loved it it was sooooo nice to install too

[@DuffyNightingale]

Seems like you could let the bed frame rails lay against the chassis and just leave a gap for the fuel filler hose.

[@shawnsavage9015]

Nice video. Is it possible to put a gooseneck hitch on that truck with the dump kit installed? If so where would you mount the hitch?

[@Veikra]

Can the truck really take 5T of payload with this installed? Seems like a lot of weight

[@antoniopineda3893]

can intall for my izusu some hoist dump

[@juliotzun4308]

any tips how to install a dump kit on a Toyota Tundra 2010

[@derek5463]

Every time he says determined take a shot of tequila

[@donaldolast]

Lol

[@josebarrera8720]

Do you know were i can get it installed un california

[@jaredj631]

Dang I don't think I would cut my chaise.

[@nealkirby197]

High hi&