Paul Naton - Setup and Tuning Model Sailplanes

[@lukethedrifter100]

Paul is a legend ❤

[@davidfalgout7304]

I have many of his video's. They are great and needed if you are wanting to be good at this!

[@jerrygiles1661]

Hello Paul, not sure if you still monitor some of these older vids but hoping...I recently acquired a pre-owned Enigma 4m full-house sailplane. Working on setting it up with flight modes, etc... You mention "mechanical" setup 1st and that brings up a question. I'm using a different tx/rx than previous owner but not sure that explains why some of the control surfaces don't line up. I'd like to mechanically center everything before resorting to any trim/sub-trim adjusting. However, the wing and tail pushrods are either a simple wire with no adjustment or in the wing, they're clevises that have been secured with glue so no adjustment there without tearing things apart. Any suggestions? Is there anything wrong with aligning everything using transmitter controls. I don't like winding up with oddball trim settings right off the bat. Thank you.....Jerry G

[@VideosByMiamiMike]

At 16:00 Paul says "Now skidding is yawing inside the turn, and skidding is outside the turn." What did he really mean?

[@owntor1]

He's talking about a slip vs a skid.