Penn International Complete Breakdown Part 1

[@anyITsolution]

I’ve recovered a set of 50W and 20s this video assisted me on learning the right technique saved me some $ for folks in low budget if you are salvaging you may need to add a few drops of oil on the screws and let it sit for a few hours as mine were so out of shape but once I got In There I was able to grease em up final product like new! Thanks again for your time and step by step guidance even the clear sound of the video..!

[@reelclean]

Thanks very much! I'm glad to see that such an old video is still helping people out there! I have some interesting content, like restoring an old Penn reel, you should check it out to see more!!

[@anyITsolution]

@@reelclean will do! I was just desperate to see the internals and this video did the trick no commercials sponsors or bs 🫡

[@normanfern2823]

How do you remove the side plate from a Penn generation v75

[@registrard1076]

Amazing

[@reelclean]

Thank you! Cheers!

[@trumpafarian7129]

What kind of drill is that? Amazing.

[@reelclean]

It was just some cheap cordless drill I picked up at walmart. You really shouldn't use a drill on your reel unless you're absolutely certain the screws aren't seized. I had taken this reel apart ten minutes before this video.

[@jerryhurst9600]

my spool want release to drop down my bait everything works fine you have any idea what might be the problem

[@reelclean]

Jerry, It sounds like one of possibly two problems. First, your drag setting may be too high at the freespool selection, or a failure of the drag cam/cam follower assembly inside the side plate. Take a video and tag me in it and I'll check it out!

[@firestorm5265]

How do you remove the handle from the Penn international V 2 speed 30 reel?

[@reelclean]

Firestorm, Unfortunately, this is not as simple as I think it should be. You must use the special wrench that was provided with you international V reel to hold the notched plate below the gear shifter in place while you turn the shifter knob counter-clockwise (as if you're switching back into high gear). The knob will unscrew and then you must remove two small screws from a plastic plate which acts as a lock plate for what's called the shifter plunger. Then you can remove a washer and viola!

[@maineoutdoorsman677]

Drag washers