Perfect Skill With Extremely Beautiful Artwork Design Machined On Wood Lathe

[@mrimmortal1579]

It is a nice looking vase, but I’m curious as to why you don’t hollow out more of the inside? Also, I notice that when you are boring the center out, your big Forstner bit is moving around an awful lot. You’re not boring the hole by hand, are you? That’s a good way to be injured! Your forstner bit should be held firmly in the tail stock chuck, and fed into the wood with the tail stock quill. The tail stock itself should be locked down whenever the bit is in the wood. When you reach the end of your quill travel, back the bit out, move the tail stock forward, lock it down and feed in with the quill again, then repeat until you reach the desired depth.

[@carpenterwoodworking]

Thank You For Supporting The Channel

[@EdRaastad-rj6mi]

Great idea, beutiful work, but as long ss you had a center hole drilled, why not bandsaw the slabs round and avoid all the knocking of taking the corners off? Asking for a friend.

[@carpenterwoodworking]

Thank You For Supporting The Channel

[@MonicaKehlet]

Love this one

[@carpenterwoodworking]

Thank You For Supporting The Channel

[@curiousworld7912]

Amazing as always, with meticulous planning and execution. Well-done, and thanks. :)

[@магомед-набипахравов-л6б]

Отличная работа., молодец! Чем покрываете продукт ?

[@ramonrosas-gu4pp]

Cuánto cuesta un jarrón como ese no se en que parte del mundo estén pero me gustaría tener 2 en casa

[@carpenterwoodworking]

Thank You For Supporting The Channel

[@BernardHouston-cx5vh]

wow

[@jeffwright584]

You all are asking questions to who ever copied this video. They didn’t do the work

[@carpenterwoodworking]

Thank You For Supporting The Channel