This video is part of the free Ansys Innovation Course, 'Obtaining Numerically Accurate Results Using Ansys Mechanical'. Access all of the course contents including additional lessons, handouts, simulation examples with starting files, homework problems, and quizzes: courses.ansys.com/index.php/courses/numerically-accurate-results/. Check out other courses on the website while you’re there. Happy learning!
@sergeydukman58323 жыл бұрын
Why do you apply load on the submodell one more time if the main modell is already solved with all applied loads?
@rupeshpatil32493 жыл бұрын
Really a helpful video. Made my work easy, simple and fast. Thank you Sir
@anthonybotting97993 жыл бұрын
At 5:31 we want RY (both axles) not equal to zero, right? I see later you set them to "Free". Good tutor. Thank you.
@amiraboodi20752 жыл бұрын
A handy feature. Thank you a lot.
@skinfoconsultancy37873 жыл бұрын
At 8:12 pedal load is applied which results in some deformation, then why is it again applied at 11:10. Doesn't it make over load than the required load?
@namandoshi5693 жыл бұрын
same doubt
@adilasbai962 жыл бұрын
There is a load in the cut region. As I see it, if it is not applied again in the sub-model, the overall load balance would be wrong.
@guillaumedonnadieu33882 жыл бұрын
@@adilasbai96 but the load is infered through the deformation data I believe. So same doubt
@ateflaiche44363 жыл бұрын
Can you guide me plz to perform component mode synthesis for simple wing in ansys workbench ?
@kxiao9402 Жыл бұрын
I would like to ask how to implement the sub-model technology in transient analysis
@AnsysLearning Жыл бұрын
Thanks for watching! Please post your query on the Ansys Learning Forum for a detailed answer from the wider Ansys Community: ansys.com/forum.
@icklono5 Жыл бұрын
İs there a possibility to do topology optimization on submodel?
@AnsysLearning Жыл бұрын
Thanks for watching! Please post your query on the Ansys Learning Forum for a detailed answer from the wider Ansys Community: ansys.com/forum.
@ilyagordievsky95303 жыл бұрын
Hi. Is it possible to turn on convergence for submodelling?
@AnsysLearning3 жыл бұрын
Thanks for watching! Visit the Ansys Learning Forum for an answer to your question. Visit at www.ansys.com/forum.
@ThePandazmr Жыл бұрын
Why did you use a fillet of 2mm and not just split the model?
@AnsysLearning Жыл бұрын
Thanks for watching! Please post your query on the Ansys Learning Forum for a detailed answer from the wider Ansys Community: ansys.com/forum.
@BharathKumar-pw2xw2 жыл бұрын
can anyone explain. HOW to create a Named selection like front wheel and rear wheel
@AnsysLearning Жыл бұрын
Thanks for watching! Please post your query on the Ansys Learning Forum for a detailed answer from the wider Ansys Community: ansys.com/forum.
@guillaumedonnadieu33882 жыл бұрын
The golden rule in ANSYS is : there will always be an Indian guy better than you