Piaggio MP3 400cc (2009) steering caliper lock issue

[@johnjalmelid7496]

Thank you!! I had never solved it without your video and comment on the microswitch!

[@BenzFarm-o9o]

It seems like every piaggio video is silent, are we to guess what's going on???

[@V8klinika]

You can find a little micro switch on the lock system under the dashboard! it was broken

[@KevinNguyen-zn4vv]

Please elaborate?

[@nikolamilojkovic5224]

Hello. Can you please tell how did you fix this problem? I have the same problem with yourban 125ie

[@samlee3934]

Thank you very much and wait for your picture

[@Jamie-o5e7i]

I have problem mine don't make no sound or it flashes on then its off any suggestions i move this switch in video and then bleeping dont go off

[@V8klinika]

Yes, of course!

[@zaracelik2030]

What did you do ?

[@TheOldcosmos]

We have MP3 300ie system gives the same fault. We took out the hydraulic oil. it gives the same problem when we turn on the ignition. We couldn't see clearly in the video, what should we do in the next stage?

[@antonius0407]

what did you actually do to resolve it, i could not see what you done?

[@V8klinika]

It was a broken micro-switch on the steering mechanism.

[@samlee3934]

H78 Motorcycle service, Battersea, London

[@luks_us]

Which micro-switch ? Where it is ?

[@V8klinika]

On the steering caliper itself, there is a switch, that was broken

[@luks_us]

H78 Motorcycle service, Battersea, London this switch ? www.moto123.com/ArtImages/122626/2010-piaggio-mp3-500-i04.jpg

[@mrapache58]

on a 250ie how do i fix the problem?

[@r3birthr3cords-adm3]

Same issue on mine

[@Laborkei]

Did you check Fluid Levels for Tilt-Lock?

[@antiveneno]

your problem was the level of liquids?

[@KeepWalkingRoadman]

Hhj

[@KeepWalkingRoadman]

Dhg 2:03

[@samlee3934]

thanks,I solve the problem.

[@santiagobladi8614]

hi, how? mine is locked

[@BernardBiondo]

Comment tu as fait ???

[@BernardBiondo]

​@@santiagobladi8614comment tu as fait

[@benjah4eva]

Bro Who is going to fix my MP3 now? why did you close down garage? And where did you move business to?

[@Zveki]

FAULT: micro switch not pressed. DIAGNOSE: what he did is actually pushing the latch, so it could go all the way back and press the micro switch. Most probably the switch was not bad. SOLUTION: loosen the cable slightly (right above the roll-lock mechanism), so the spring can bring it back all the way and thus the micro switch could be pressed.

[@V8klinika]

@@Zveki in this case the microswitch was broken

[@Zveki]

@@V8klinika the fault has been eliminated after the procedure, so my thoughts were the switch was good. Otherwise the fault would still be present

[@samlee3934]

I can't see what you pull it

[@V8klinika]

I'll have a look if I can find a picture of the switch I'm talking about. Thanks.

[@BernardBiondo]

Bonjour mon scooter fait exactement pareil que faut-il faire exactement je vous remercie d'avance

[@szabitraxxas1061]

Sziasztok! Ugyanez a problémám van az mp3-mal, segítséget szeretnék kérni,mit nézzek meg,a fék nálam behúzott állapotban van. Köszönöm szépen Üdv.:Szabi

[@V8klinika]

Szia! Írj rám a H78 Szervíz Szentes FB oldalon! Köszönöm

[@dasilvasuzana4306]

bonsoir je voudrais savoir ce que tu as fait

[@V8klinika]

I don't understand!!

[@cherietsofiane6802]

Une solution ?!! même problème sur mon 400

[@cherietsofiane6802]

@@V8klinika what is a solution ?!!

[@christophesene4576]

CHERIET SOFIANE J’ai la même chose sur mon MP3 400 c’est quoi le problème

[@nellys.r.4449]

Il dit que c était un micro bouton en dessous du tableau de bord. Mais dans mon cas ce n est pas ça. Impossible de trouver ce qui ne va pas. Tout a été fait (changement d'huile, test 12v etc) c est l enfer ce truc...

[@esauperalta5672]

Amigos ayuda el mio suena horrible ya esta desbloqueado y no deja de sonar ya no se que hacer 😢

[@mirosawsabut3771]

Po co te filmiki jak nie wyjasnia co trzeba zrobic

[@sylwiasteginska1533]

I jak się udało naprawić ten problem.

[@V8klinika]

English please

[@KF1]

@@V8klinika he asked how you fixed it?

[@dasilvasuzana4306]

jai changer les roulement purger le rolllock mais ca sonne et ne fonctionne pas help me please

[@V8klinika]

www.boonstraparts.com/en/part&ID=B10000DMHB , couldn't find the original picture, but please see this link, this is the one I am talking about.

[@mrapache58]

mine ran out of fluid, I refilled it and it worked that evening, turned it off and the next morning the beeping came back on and now its stuck w the constant beep.

[@mrapache58]

mine did the same thing, did u solve the problem?

[@jeffzheng7171]

hello I am from China

[@lizzz0921]

Hola! Tengo el mismo problema! Alguien me puede ayudar porque no entiendo que es lo que hace? Gracias!!!!!

[@aerum]

Si lo averiguas dime, porque estoy igual...

[@wallyouyeahh]

que demonios hizo?