Pierce in Fiber Laser Cutting | Perforation in Laser Cutting 2

Our Store/Nuestra Tienda: spierlaser.en.alibaba.com
Contact: [phone] [e-mail]
The video will talk the "Pierce" in fiber laser cutting and perforation in laser cutting. There are two videos "this video and last video". We will continue “Pierce”, talking some experience and the common problems.

[@rackhir100]

Excellent video!

[@bonifacemwaura6993]

Very informative!

[@user-cz9yq1uc9e]

Thank you! Super!

[@tuxMac25]

Hi Clara, I didn't quite understand one thing, regarding point 5, does reducing the auxiliary gas pressure increase or decrease the perforation time ?

[@lamania32]

Hi Clara I'm so pleased you started to the video series on Cypcut, and laser cutting in general. Would please make a video about the focusing the laser beam on a manual laser cutting head. On thicker materials vs thin materials Thank You

[@bogdanilietalmaciu7912]

Hello Clara!

[@OGJuanClaponi]

Hi Clara, thank you for all the information. I have a question. On our 4kW Laser, the pierce is good but it is shooting alot of sparks out of the top and my nozzle is getting real dirty during pierce to the point that it will not allow me to cut the entire sheet properly. What parameters should I start looking at? For Reference, the material is mild steel, 3mm and I am using oxygen. When I cut the same material with nitrogen, the pierce and the cuts are beautiful but I cant seem to keep the nozzle clean enough to get the same effect with oxygen. Thank you very much.

[@HashamSheikh09]

Hi Clara, I have one question, right now i have one laser marking machine which is used to mark on stainless steel base but right now its not marking on it, for testing i marked on aluminum plate its working well on that but not on base which i normally use for marking, is this machine loses its power ? or there is some thing else? kindly guide me. machine is only

[@MarceloMartinsitu]

Olá Clara, é possível fazer um furo de 6mm em uma chapa de 10mm com qualidade?

[@fadighossain1532]

hello Clara...Thank you for your videos ❣....i am cutting 3mm CS with my 3000watt machine without piercing, the cut is Good and ok 👍.....does cutting without Pierce effect or damage the lenses or the head?

[@dopple33]

Hello Clara, thank you for the informative video. I have a question: in CypCut, what is the meaning of "Lighting Pierce", "Segment Pierce", and "Follow Pierce" in CypCut?

[@muhamadalfatih3114]

What is This stainlessteel or mildlsteel .we can do stainlessteel focus minus but you say mild steel it plus in focus deferent can ido and setting my mechine.i use bodor laser 4kw

[@hesamjabbari9762]

Hello Clara i have 3kw laser fiber raycus but i can’t set pierce parameter even i watched your post about set parameter but i can’t work with your parameter

[@hbsupermage]

when my laser machine starts the pierce it will make a huge explosion, and make a big hole, i have tried 2 stages, 3 stages, direct, max power, very low power, long piercing times, short piercing times, and it always does the same. (im trying to cut 4mm mild steel with oxygen) the blow is big, and the hole is irregular, making the following cut to be very big and irregular

[@nagarajan6597]

Hai my friend

[@nagarajan6597]

I have a 6kw laser but don't set any parameters... How to set parameters

[@nagarajan6597]

I'm in Kuwait

[@nagarajan6597]

I'm buy machine in chaina... Now corono time so no one come to here