Pilot Rc 84” Slick stage build video 4- 12 January 2022

Hi guys.. stage build video 4 Pilot Rc 84” Slick Rudder installation.. thank you for your interest guys by subscribing you will get future notifications and updates with upcoming videos and to keep my channel going appreciate it guys enjoy and fly safe! 

[@Up-ey6tm]

Nice video and design! Btw, did it mean NO GLUE for rudder installation??

[@dannyporter888silverfox8]

Hi up2368. You don’t need any glue for the rudder. 👍

[@martynperks7326]

Rudder pin in upside down, no thread lock in sight on anything.

[@dannyporter888silverfox8]

Hi Martyn. Yes I fitted the round pin differently I fitted my way because I didn’t like the pin at the to where you can see it.. the pin I fitted is very tight and stable not go anywhere.. I have tested it so is all ok Martyn.. fly safe 👍

[@volvolailai]

Hope your Video soon

[@dannyporter888silverfox8]

Thank you volvola289 👍

[@roelmichielsen9819]

I have the same plane but I don't have the pin that goes into the rear wing

[@dannyporter888silverfox8]

You need to contact the shop where you bought your model from.

[@callumsetter6601]

i think your ment to push the rod through the top of the rudder the 90 degree bent was there for a reason and then the collar goes at the bottom, loving the videos mate keep them going

[@dannyporter888silverfox8]

Hi Callum..thank you for your interest on my channel.. on the AJ RAVEN you push the 90 degrees bend through the top but on the pilot Rc you push it from the bottom and through the top of the rudder post there is a little hole for it to fit through.. at least that it what I thank and because Pilot Rc doesn’t come with any instructions or literature for any kind of fitting.. I fitted it the way that it worked the best seems okay though.. 👍

[@PRHeli]

Can confirm. On my Slick 84, I pushed the rod through the top of the rudder and let the 90 degree bend rest on top of it. Bottom part is where the collar and an additional oversized plastic washer went that pushes against the fuselage and the rudder to clamp the whole thing down.

[@dannyporter888silverfox8]

Oh that would mean it’s the same as my AJ RAVEN fitting is the same.. the only thing I didn’t like about that is the top off the Rudder you can see the metal rod bending at 90 degrees..What engine or motor are you have in your slick Callum?? 👍

[@jb_fpv5090]

I pushed the rod through from the wheel side to the top, removing the collar. The 90 Deg bend went right up to the lower hinge. I then popped the collar on the top of the rudder, tightened it leaving 0.5mm so it just doesn touch the solarfilm. I then cut off the excess rod at the top against the collar.

[@dannyporter888silverfox8]

Yeah that seems to be the best way to do it pascal 👍