Hello, I need this study for my thesis, and I also need to know how it was done, can you help me?
@CAESHOPАй бұрын
I shell the ACT used to define the Archard Wear. if you want, you can send an email to: caeshopsp@gmail.com
@victorzhang88694 жыл бұрын
hello sir: may I ask how to setup the pin-disc wear analysis on ANSYS? I want to do the relative experiment. Thanks
@jayakrishnajay17992 жыл бұрын
I want full video
@abhishekkhilari3801 Жыл бұрын
Hi, interested in the tutorial.
@ananthapadmanabhanm18493 жыл бұрын
Can you show the detailed video
@ghazwaninordin4523 жыл бұрын
sir, i would like to know the procedure
@mohamedkalifa91912 жыл бұрын
Hi , Please, I am looking for your experience in mechanical engineering
@Y9096841236D4 жыл бұрын
Deformation is 120 mm ? 12 cm ? Quite large deflection ? что-то не так
@CAESHOP4 жыл бұрын
it is Total Deformation, not Direction Deformation. mean, it include both rotation deformation of disc
@venkatasomireddyjanga56426 жыл бұрын
hello can u send this tutorial I would like to buy , what is ur price?
@sennjivallagu18835 жыл бұрын
Hello, keen to know the step by step procedure, can you please help me out?
@sennjivallagu18835 жыл бұрын
Can I get your email address please
@CAESHOP5 жыл бұрын
yes, just contact with me via email: caeshopsp@gmail.com
@venkatasomireddyjanga56426 жыл бұрын
Sir , Is this wear analysis done in Transient Structural? Can you give the pdf or doc explaining how to apply boundary conditions and how to get graph.(Procedural steps). Thanking You sir
@CAESHOP6 жыл бұрын
I have completed the calculation using Transient Structural and wrote the tutorial. But, it's not free.
@iqbalroghani17596 жыл бұрын
what,s the price sir?
@CAESHOP6 жыл бұрын
Please give me your email, i'll sent info.
@iqbalroghani17596 жыл бұрын
iqbalroghani8@gmail.com
@rodrigo64165 жыл бұрын
@@CAESHOP Send me please, my email is: rodrigoarcanjo123@gmail.com
@boutayebmo39825 жыл бұрын
Sir, keen to know the step by step procedure, can you please help me out?
@CAESHOP5 жыл бұрын
yes, just contact with me via email: caeshopsp@gmail.com
@UppadaRamakanth5 жыл бұрын
Sir pls send step by step process of wear analysis in ANSYS
@sammedtalandage46484 жыл бұрын
can i be able to run this type of simulation for given rpm for at least 30 min? if yes i m interested in buying