In episode 7 Jeff Baker goes through the step by step process of pinning the 2014+ Chevy Silverado & GMC Sierra 10 cut ignition lock. For more aftermarket solutions visit us at aftermarket.str...
Пікірлер: 19
@renedelrio80424 жыл бұрын
Great video as I am in the process of replacing one, and I got stuck with missing the step with the retainer. Hopefully I can try this again tomorrow and get this vehicle on the road again.
@benjasvargas85645 ай бұрын
Thank you So much for the video you the best
@felixcordova42822 жыл бұрын
Is there a video on how to disassemble after coding ?
@bradhartsoe91283 жыл бұрын
How do you remove the cylinder from the ignition Lock Housing if the key will not turn?
@tinhtran13093 жыл бұрын
I try for my truck but can not put in?please help me
@thegonz78339 ай бұрын
Strattec 7024124 GM Ignition Lock..2016 sierra bought new,135k,pulled into rest stop,got back in,key would not start to go in.F'd with it,finally took oil from dipstick onto key,got it to go in,giggled until it turned.Giggling would get it to turn ordered part next day.No warning fail.How about you,quick fail? miles?
@thegonz78339 ай бұрын
This vid helped 100% i did have to tap the collar sleeve on.with nothing in the cly it would not slide on.All seems good but dont like the force needed compared to this dude sliding it on. Strattec 7024124 GM Ignition Lock
@jacobgoodwin7491 Жыл бұрын
Very helpful! Had an issue with a 2016 GMC Sierra, I was taking the ignition tumbler out to replace the ignition switch and didn’t realize the front most shaft got stuck in there. Used your video to figure out how to put the locking tabs in with the spring. Thank you for detailed video!!
@jonnysanchez98511 ай бұрын
How’d u get the shaft out
@mohsinturabshah42534 жыл бұрын
👍🏻 thanks sir
@rhettquinn5656 жыл бұрын
this was very helpful :)
@Middle_American3 жыл бұрын
Thank you for this video. I was able to use this video for guidance to change the cylinder on a 2014 Silverado.
@CarlosFlores-zv5pv Жыл бұрын
Tnx for your time and knowledge very well explained video and audio are perfect tnx
@felixcordova42822 жыл бұрын
Is there a video about how to disassemble the ignition after coding
@DIYeverything5132 жыл бұрын
Awesome video very very clear and helpful.
@josephjennings9246 Жыл бұрын
So what’s the cuts
@cw42095119 күн бұрын
Now make a video on how to put the cylinder into the ignition housing