Pioneer XDJ - RX2 power up problem.

[@leewright6101]

i think the 3.3v blows to cpu,, causing no 3.3v to power the processor but 5v line exsists and here he tails off the 5v line and the resistor gives the cpu a 3.3v maybe 3.3v lines to be looked at or on top side i knwo theer are 2 transistors that one is 5v one is 12v maybe a failure off this to cpu,, THE 220ohm resistor pulls down the 5v line to 3.3v , basically might be better getting a 3.3 buck converter from 5 or 12v to 3.3v. resistor in time might get too hot and fail.. so i would say use a buck converter, i have found in few of these that the 5 pin chip next to the grey cable is a voltage reg 3.3v to cpu,, this fails,!!

[@leewright6101]

plus,, ive tried this nothing new psu but lookin at yours ypu also have also done something else. inbetween as i can see either join,, or resistor bank does show too clear,

[@ardjavachannel5196]

hi friends. the resistor and switch are just a replacement for the actual on/off switch.

[@user-lq9hi4xv4i]

hi, did you have to buy something to fix the problem or you just open the xdj and did something without have to buy anything? My XDJ RX2 is blinking the master rec button and wont turn on. Pls help me

[@andreabinni1443]

Salve fratello mi potresti dare un aiuto spiegando bene cm risolvere il problema grazie dall italia

[@leewright6101]

can u show us the solder points better ,, please cheers lee. cant see where grey wire solders too, thanks,

[@ardjavachannel5196]

leave a message on my WA number. I'll definitely reply

[@Mauro_Vilas_Boas]

Qual resistor vc usou ali na chave? 22 ohms ou 220 ohms?

[@ardjavachannel5196]

220 ohm

[@jorrelvelasco2033]

Pls 🙏 hilp

[@loobisi]

why did you record and upload a video about this and not explain what is the problem and how it can be fixed. This is just ridiculous

[@nativeplussounds]

Bang kalau colokan headphone gak bisa gmna ya

[@ardjavachannel5196]

Di cek dl.apa memang dari konektornya bermasalah.atau dr amp headponny

[@nativeplussounds]

Halo

[@ardjavachannel5196]

Hi

[@djselmy1994]

Apa k itu putus jalur dari switch on off ??

[@ardjavachannel5196]

Tidak.itu hanya switch penggati.untuk memudahkan proses perbaikan

[@djselmy1994]

Bang kalau boleh tau nilai power supplynya brapa volt dan ampere

[@ardjavachannel5196]

Power buat start up nya 12v.cuman di bagi lagi ad 3.3 eup