Taking a closer look at the Passive Infrared Sensor. Testing out different configurations as well. Code: github.com/Rob...
Пікірлер: 13
@maker.kylesu2 күн бұрын
Absolutely great video, so useful! Thank you for sharing
@Th3Mafia Жыл бұрын
best vid on this device i have found, others are scatter brain thank you
@robotsanddinosaurs Жыл бұрын
Thank you, appreciate it 🙏
@ted_van_loon4 ай бұрын
in the datasheet, the R and I mode where labeled in the opposite way, expected it might have been a mistake in the datasheet, but since I didn't know if the 3.3 would trigger the arduino(while it should) s well as other things I might have made a mistake at I decided to look at someone using it, and luckily the datasheet just had those 2 the wrong way around. also my code for testing was: void setup() { pinMode(7, INPUT); Serial.begin(9600); } void loop() { Serial.println(digitalRead(7)); delay(100); }
@markharrisllb3 жыл бұрын
A very useful video, thank you.
@bunch8 Жыл бұрын
What part # or resistor value are the LDR and Thermistor? Thanks for your useful video.
@robotsanddinosaurs Жыл бұрын
You're welcome! Thermistor is 10k I think, not sure about the LDR.
@Mohammad-kf1tg11 ай бұрын
Helpful video thanks very much
@jeffD15 Жыл бұрын
thank you so much!
@robotsanddinosaurs Жыл бұрын
You're welcome !
@anandjoshi85542 ай бұрын
@@robotsanddinosaurs in re trigger mode H > if u increase delay time > then after u left the room, output/load remain high ,until the end ofduration of delay time set !!!!