PLA DUAL COLOUR SILK Filament Showcase | Bambu Labs Two-Tone Magic!

[@miloszkwiatkowski7449]

what profile are you running these on. also what's outer and inner speeds? 0.4 nozzle? please ans thank

[@DraftID]

0.4 nozzle and at 0.2 height, I did slow the speeds about 60% since I was using a silk material.

[@ronaldhoppus9015]

Those don't look too good? Was someting not correct?

[@DraftID]

I think there is something weird with this model as no matter what material I used there was always artifacts in one spot. Some comments on the model where saying the same thing. So yeah I think its something with the model itself.

[@AndrewSmith-du6qn]

Yeah NGL the print quality on those looks terrible especially if you're trying to showcase the nice look of a new filament.

[@CharlieToof]

Why the print looks so dirty? Are u able to calibrate your printer?

[@DraftID]

I’m not sure what was happening with this model but I was getting the same issues across all the filament I used. Other model prints were fine though. Might have been something wrong with this one.