Рет қаралды 4,433
This is a video of a plastic model, MODEROID True Getter 1.
This time, when I looked at the instruction manual, I thought that there are quite a lot of abs.
Craft: Since there is a possibility that the abs will break even with water-based paint, I used nippers to make a small cut in the pin holder at the time of assembly to reduce the pressure when the pin is inserted and to prevent cracking.
I also modified the shoulder to have a prominent joint so I modified it afterwards. I think this made painting easier.
Since the arms and ankles can not be processed by post-fixing, I erased the joints after painting them.
Next, I wanted to pose the Getter Beam, which is an essential part of Getter Robo, so I used Kotobukiya's and Wave's modified parts and putty to make a firing port for the Getter Beam.
Finally, I was worried about the size of the weapon parts, so I increased the thickness of Getter Tomahawk by using 1mm and 0.5mm plastic plates and extended the Getter Sight by making the blade part with plastic plates.
I used Mr. Hobby's Weathering Master for painting. I usually use Tamiya's Sumire enamel paint, but I used this to reduce the possibility of cracks.
0:00 Opening
0:11 Bock Art Instructions Proportion Check
0:38 Crack reduction Surface treatment
3:45 Post-framing of shoulders
7:23 Getter beam launch port construction
12:30 Getter Tomahawk modification
15:42 Getter sight modification
18:59 Painting
23:11 Comparison of finished products and various poses
I hope you will be able to bear with me until the end of the project. Thank you very much.
DOVA-SYNDROME
dova-s.jp/_mob...
#modification
#plastic model
#moderoid