PolyWorks Series - Webinar #2 - Datum Alignment to CAD and Apply Color Map

[@d.a.benton1393]

Thank you very much for the knowledge sir however at 33:41min. Datum B and C are not over constrainted? "A"s lock the part on Z axis and Datum B must lock in X & Y and Datum C must lock for rotation only. Which is X axis.

[@OmarRios89]

Great information. If I had been in that webinar, I would have a lot of question to the instructor.

[@d.a.benton1393]

Also sir I could not get that why bottom and top parts are merged on each other's? Would not these parts make an assembly such as a closed box?